Recommended Lightweight Ramp For Changing Oil in 2000 Chevy Sliverado

Question

Question:

I have a 2000 Silverado that I need a ~ 4-5 inch extra under for oil changes will these ramps work for me? or do you offer a different product that would be better? thanks

asked by: Mike

0

Expert Reply:

The # RR-30 will give you an extra 5 inches of height, so they should work perfectly for you since you were looking to gain an extra 4-5 inches of height. The ramps are compatible with vehicles weighing up to 6000 lbs. The ramps are also lightweight and very easy to handle.

To determine if the approach angle of your truck is compatible with the rams, use a yardstick and take a measurement as outlined in the diagram I've provided for you.

expert reply by: Mike L

0

click to enlarge

Answer 1

Your 2019 Chevrolet Corvette has a 18 degree approach angle. This will allow you to use the Race Ramps Rally Ramps #RR-30 as they are capable or an approach angle down to 16 degrees.

view full answer...

Answer 2

In order to determine the correct wheel stabilizer for your tandem axle trailer, you need to know the spacing you have between your wheels, as there isn't a standard spacing for trailers based on size. So all you need to do is take a quick…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Recommended Lightweight Ramp For Changing Oil in 2000 Chevy Sliverado

Product Page this Question was Asked From

Continue Researching