bing tracking image
Q & A Icon

Recommended Flat Towing Set Up for a 2013 Ram 2500  

Question:

I want to flat tow my 2013 Ram 2600 Cummins with 4x4. Can you advise on the parts I need? I would prefer not to have magnetic lights.

1

Helpful Expert Reply:

I would be happy to help you set your 2013 Ram 2500 up to be flat towed. I have listed the parts you will need below along with any installation videos we may have. The wiring harness will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies so no need to worry about magnetic lights.

Tow Bar and Safety Chains - Roadmaster Blackhawk 2 Tow Bar item # RM-422 and item # RM-653

Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Fixed Arms item # RM-296-2

Wiring Harness - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit item # RM-15267

Supplemental Braking System - Brake Buddy Select 3 Portable Supplemental Braking System item # HM39524

High Low Adapter - The tow bar needs to be within 3" of level. If you measure the height of the inside top of the hitch receiver tube on your RV, and the height difference is more than 3 inches above/below the base plate tab height, you'll need a high/low adapter. I have linked a FAQ article that explains all this in more detail along with our selection of adapters.

expert reply by:
1
Jerred H

Products Referenced in This Question





Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>