5-Way Trailer Wiring Solution for 2021 Dodge Durango

Question

Question:

Do you have a five Pin flat wiring harness for a twenty twenty one dodge durango

asked by: Darin R

1

Helpful Expert Reply:

Since 5-ways aren't super common and 4-ways are we only have custom fit 4-way kits that fit your 2021 Dodge Durango like with the Tekonsha part # 118617 but it can very easily be converted to a 5-way with the adapter part # C57187 which basically just plugs into the 4-way and gives you an additional circuit you'd run up to the reverse light circuit.

expert reply by: Jameson C

1

Answer 1

We have a very easy to install 7-way wiring kit that fits your 2020 Dodge Durango with the Tekonsha part #TK22113. This comes with everything needed for a plug and play install of a 7-way on your Durango!

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 6

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 8

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 9

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has…

view full answer...

Answer 10

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 12

According to the install instructions for the Tekonsha 7-way part #TK22113 that fits your 2018 Dodge Durango the blue wire gets routed through the grommet in the floor on the driver side into the rear cargo area and then routed behind side cargo…

view full answer...

5-Way Trailer Wiring Solution for 2021 Dodge Durango

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching