How To Determine Which Replacement Door Keys Are Needed For a 1998 Wells Cargo Enclosed Trailer

Question

Question:

Hi, I bought this trailer used and without keys. It has key # VL 251 on each of the three door locks. Could you recommend anything I would like to purchase 4 of the keys

asked by: Larry E

0

Expert Reply:

In order to find the correct replacement keys for your 1998 Wells Cargo Enclosed Trailer, you are going to need to find out brand of the lock and the key code.

For example, if your key code was 251, then you could use the:

-Replacement Key for Bauer RV Lock # BA55ZR.

You should be able to find the key code on the inside of the lock either or a sticker or printed on the lock itself. You may need to remove the interior handle portion to get to the actual lock.

If you need anything else feel free to come back and we'd be happy to help.

expert reply by: Bryce D

0

Answer 1

Yes, you have the Global Link RV Entry Door Locking Latch Kit part #295-000002 so the correct replacement key for your Wells Cargo Trailer is the Replacement Key for Global Link RV Locks (316) is part #295-000042.

view full answer...

Answer 2

Since heat rises I would at the very least put a set of the Trailer Vents #HMAV2-AVT2 near the top of the trailer to get the hottest air of the trailer out. What you could do for maximum air flow in your trailer is have a set facing forward in the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I would be happy to help! While we do not carry the Glo-Brite 9500-88 you have in your trailer, we do have a light that will work as a replacement for you. Based on the information I could find on your light it measures 2" in diameter, and based…

view full answer...

Answer 7

The manual for the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters - White #AT91230 lists the wire as orange but the manual for Atwood water heaters like AT94022 list the wire as red. It's referring to the wires…

view full answer...

Answer 8

When determining what screen door latch you would need either the right hand or left hand side you would need to look at the closed door from the inside of your RV. The latch location is the side of the door that it is mounted on. This would mean…

view full answer...

Answer 9

You can replace it with the same fireplace which would be the Greystone 26" Electric Fireplace with Crystals - Recessed Mount - Black Item #324-000069. This unit will fit right into your cutout with the same exact mounting holes.

view full answer...

Answer 10

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

view full answer...

Answer 11

If you indeed have a Bauer lock, we offer a replacement 351 key as part #BA55ZR.

view full answer...

How To Determine Which Replacement Door Keys Are Needed For a 1998 Wells Cargo Enclosed Trailer

Product Page this Question was Asked From

Continue Researching