Replacement Amber LED 0277614 Clearance Light for 2021 Jayco Motorhome

Question

Question:

I’m looking for this LED clearance light. This is for a 2021 Jayco Allante. Motorhome. 0277614 LIGHT,MARKER .75 AMBER PC2 WITH GROMMET

asked by: Daniel W

0

Expert Reply:

Thanks for reaching out!

According to my research you're needing the Amber LED Trailer Mini Clearance and Side Marker Light with Grommet # MCL10AKB. The light itself has a 3/4" diameter which looks to match what you have on your 2021 Jayco motorhome.

Attached is a review and installation video for you to check out!

expert reply by: Jon G

0

Answer 1

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

view full answer...

Answer 2

I can't speak for all trailer clearance and or marker lights but most like the LED Trailer Clearance or Side Marker Light with Reflex Reflector part #328-K-51 feature a simple two wire install, one for power and one for ground. If you aren't…

view full answer...

Answer 3

The Chrome Trim Ring for Command Electronics Oval LED Clearance or Side Marker Light part #328-89-386 does just snap over the lens of the LED Trailer Clearance or Side Marker Light with Reflex Reflector part #328-K-52 or part #328-K-51. You are…

view full answer...

Answer 4

It is not uncommon for certain factory brake controllers to have issues with electric over hydraulic brakes. This would be the first we have heard of this issue with a 2023 Ford F-350, but it is possible that the brake controller in your ford is…

view full answer...

Answer 5

Considering the limited space that you have in your truck camper the Thinline Opti-Brite LED Interior Strip Light - 21-7/8" Long x 1" Wide x 5/8" Thick Item #ILL72CB is a great choice. I linked a video review of this light for you.…

view full answer...

Answer 6

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

view full answer...

Answer 7

Manufacturers do not list the part numbers they use to the public so I would need to see the actual part numbers listed on the slide out motor to determine the correct replacement. I've attached a picture below of where the stickers are typically…

view full answer...

Answer 8

We do have what you need to replace the UFP HD-1377-10 hub and drum as well as add hydraulic brakes for your boat trailer. Here are the exact parts you will need: - Dexter Trailer Hub and Drum Assembly #84546UC3 - Hydraulic Trailer Brake Kit -…

view full answer...

Answer 9

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 10

Since your old V-bar light only uses a single wire it grounds the light through the mounting hardware. You will simply need to add a Ring Terminal #DW05736-1 to the ground wire on the V-Shaped Identification Light Bar #TN23MR. Then you will be able…

view full answer...

Answer 11

You can replace the 6 diode lights with LED RV Interior Light with Switch - 9 Diodes - Surface Mount part #328-K-1050Q9 without an issue. The 9 diode lights are a safe replacement because LEDs do not draw a lot of power so you would be fine using…

view full answer...

Answer 12

The LED Trailer Mini Clearance and Side Marker Light with Grommet #MCL10AKB will fit best with a wall (or bracket) thickness that is just under 5/16".

view full answer...

Replacement Amber LED 0277614 Clearance Light for 2021 Jayco Motorhome

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching