Mounting Instructions For The Progressive Dynamics RV Power Control Center PD4135K  

Yes, all you'll need to do is disconnect the three wires running from the converter section in your Progressive Dynamics 4100 #PD4135K from the AC distribution panel (circuit breaker, ground bus bar, neutral bus bar). This will cut the…

Yes, the red wires of the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K are going to be labeled with a 3-digit code with 001 being the wire for your battery's positive post and…

The Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel #PD4135K is going to wire in the following fashion: On the front of the unit you'll have a green, white, and black wire. The green wire will…

In one way or another, the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger part #PD4135K is grounded to the chassis although it's a bit different for the AC and DC side. I have attached for you below…

According to Progressive Dynamics, with the 35 amp Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4135K you will need 8 gauge wire. I have added a link to a video review for you to check out as well.

The Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K uses a 30 amp main breaker and 20 amp branch breakers, as you can see by the cut out of the linked directions I added.

There is no need to install an inline fuse between the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp item #PD4135K. The system includes a number of safety features. It has a reverse polarity…

When you installed your Progressive Dynamics RV Power Control Center #PD4135K did you insert your DC fuses into the ports to complete the DC side of the installation? If you did I recommend doublechecking that they haven't been blown.…

The white wire on the back of the Progressive Dynamics 4100 Series RV Converter #PD4135K just needs to be ran to the negative terminal on the battery.

The black wire you have shown is power for the converter that's built inside the Power Center #PD4135K. You'll need to wire it to a 15 amp circuit breaker on the AC side of the power center.

Having been around these quite a bit I can say that for the most part the fan of the #PD4135K is typically off unless the battery is was drained and really needed to charge back up. Typically these are installed in a cabinet so a lot of the noise…

The main AC breakers of the #PD4135K should be 30 amp. As far as wiring we have to recommend you stick with Progressive Dynamics and consult a licensed electrician or RV tech for the wiring and install of the kit. On the panel with the fuses the…