Mounting Dimensions For Folding Step Assist # PLR900

Question

Question:

What is the diameter of the mounting holes on the step?

asked by: Stan Z

0

Expert Reply:

Per the manufacturer The Folding Assist Step # PLR900 has a mounting hole dimension of 4 inches center on center.

expert reply by: Noah E

0

Answer 1

The service plan for the Galeo Pro part #GA94FR is offered in three time frames currently: Monthly/yearly/3-year service available from Galeo at $1.99/$19.99/$49.99.

view full answer...

Answer 2

When the battery dies on the Galeo Pro GPS Tracking Device #GA94FR you have to replace the sensor as they do not offer a replacement battery. The battery is hardwired into the unit and not something that can be replaced.

view full answer...

Answer 3

The Galeo Pro GPS Tracking Device #GA94FR will need the tracking service plan to tell you where the vehicle is. The service plan is what allows the device to communicate over cell service its exact position.

view full answer...

Answer 4

I contacted Polar and they were reluctant to give me a weight rating for the step part #PLR900 however they were adamant about the fact that it can handle 210 lbs of weight. The step is designed to be used on industrial equipment so it is made of a…

view full answer...

Answer 5

The Galeo Pro GPS Tracking Device #GA94FR will update the location when you press the "Locate" button in the app. Otherwise you will get push notifications when it detects movement so you know when your trailer is being moved around - which…

view full answer...

Answer 6

The HitchMate Boat Trailer Step #HE4036 does only come as powder coated steel. This will offer corrosion resistance, but it will also need to be kept clean to keep this up. We do have a galvanized step available, but it is a different design. The…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Mounting Dimensions For Folding Step Assist # PLR900

Product Page this Question was Asked From

Continue Researching