Ark Ezi-Guides Self-Aligning Boat Trailer Loading System for a 13 Foot Boat

Question

Question:

I have 13 foot Smokercraft Alaskan boat it probably weigh more than a lot of 14 foot boats, 20 hp suzuki motor batteries and with bow trolling motor. how much pressure does it take to push down the rollers?

asked by: Steve

0

Expert Reply:

The Ark Ezi-Guides Self-Aligning Boat Trailer Loading System # AR64FR is categorized by boat length and not weight. I contacted the manufacturer with your question and they did not tell me a specific weight, but that the Ark Ezi-Guides Self-Aligning Boat Trailer Loading System # AR64FR would be the correct system for your 13' boat.

expert reply by: Scott S

0

Answer 1

The installation process of the Ark Ezi-Guides Self-Aligning Boat Trailer Loading System -part #AR84FR is very easy and can be done by you easily. It will use u bolts to wrap around the trailer frame and you will then tighten them down with either a…

view full answer...

Answer 2

I don't have a video I can share with you, so the attached photos are the best I can do to hopefully give you an better idea of how the Ark Ezi-Guides Self-Aligning Boat Trailer Loading System - 20' to 28' Long Power Boat #AR84FR work.…

view full answer...

Answer 3

Length of boat typically correlates with the weight of the boat more than any other figure and it's pretty easy to determine length so that is why the Ark Ezi-Guides Self Aligning System part #AR64FR has a length range listed. This one is for 14…

view full answer...

Answer 4

I do have a photo of the Ark Ezi-Guides Self-Aligning Boat Trailer Loading System part #AR84FR installed which you can see below. This should give you a better idea of what is involved but it's not complicated at all. These work really well and…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 7

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 8

For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise they…

view full answer...

Answer 9

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Ark Ezi-Guides Self-Aligning Boat Trailer Loading System for a 13 Foot Boat

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching