Is There a Lift Kit for a Keystone Montana with MORyde LRE Suspension

Question

Question:

I wish to lift my 2007 Keystone Montana 3075 RL with the Morryde LRE suspension system. Do you have any products that do this without removing the large center spring hangar? I also use the X-Factor cross braces.

asked by: Barry D

0

Expert Reply:

I do have a lift kit that is compatible with a Keystone Montana in the Correct Track Trailer Alignment and Lift Kit part # RR23QX. This kit attaches to the leaf spring hangers and extends them to provide lift of 1-1/4" or 2-1/4". This is the only type of trailer lift kit we offer for leaf spring trailers.

Unfortunately, the Correct Track Trailer Alignment and Lift Kit is incompatible with the MORryde LRE Suspension System.

expert reply by: Conner L

0

Answer 1

Okay let's get started here with the suspension for your 2012 Skyline Koala 27CDS with 3,500 lb Axles; for the first part regarding your equalizers and suspension upgrade kit, so long as your current equalizer is spaced 6 inches (or close to it -…

view full answer...

Answer 2

It is normal for the rubber to push out of your MORryde Shock Absorbing Suspension Equalizers #MR27ZR the way it is. The main issue I see is your Shackle Strap #TRSL313 is wearing out. I can see a bit of the hole on the top left strap which means the…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 5

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

There unfortunately isn't a guide to tell us the equalizer, shackle straps, and leaf spring sizing for your 2016 Grand Design Reflection 313RLTS so you'll need to a bit a of measuring to determine the best replacements. Before measuring…

view full answer...

Answer 8

You will definitely want to go with the Road Armor Shock Absorbing Equalizer Kit #LC696740 over the MORryde as the Road Armor has more travel and will provide a smoother ride. Then, in regards to shackle straps I'm not sure what you mean by which…

view full answer...

Answer 9

Yes, going from a 4 leaf to a 6 leaf spring would add slightly to your ride height. For example, if the current 4 leaf spring has 3/8" thick leaves, and you go to a 6 leaf spring with 3/8" thick leaves, you would be adding 3/4" of…

view full answer...

Answer 10

Hey Skip, in order to get the right size upgraded wet bolts you're going to need to let us know what size wet bolts you currently have are. For instance, if you had a 9/16" x 2-15/16" wet bolt then something like the Replacement Wet…

view full answer...

Answer 11

The wet bolt and shackle kit part #LC52SV that you want to use with the Road Armor #LC696740 does not come with leaf spring bushings but we can help with that. I believe what you are looking for is bronze bushings like the part #K71-291-00 as brass…

view full answer...