Bright Strip Light for Utility Trailer

Question

Question:

Made a utility trailer into a camping trailer, what lighting should I go to get the best brightest lighting, I need to install 2. 16inch enclosed trailer.

asked by: Tim B

0

Expert Reply:

For a 16 inch strip light that would be the brightest our best solution would be the Optronics part # BUL69CB that you referenced as it's the closest in length at 15 inches and is very bright. Our customers have reviewed this highly and have told us that it's very bright.

expert reply by: Jameson C

0

Answer 1

The correct chrome base to use with the #BUL69CB that you mentioned is the part #A69CB that you mentioned.

view full answer...

Answer 2

I may have a few parts that you can piece together to install tail lights on the Curt Cargo Carrier, #C18100, but Curt does not offer a tail light kit that will fit this carrier. If you are interested in the slim LED lights, you could install two of…

view full answer...

Answer 3

For the Hopkins Endurance 4-way part #HM48244 the ground wire is 16 gauge and all other wires are 18 gauge.

view full answer...

Answer 4

The #BUL69CB LED Utility Light Bar you mentioned can be used for utility use or general illumination, but is not certified by the DOT for use as a back-up lamp as it would be too bright.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Bright Strip Light for Utility Trailer

Product Page this Question was Asked From

Continue Researching