Chrome Base for Interior Light BUL69CB

Question

Question:

What is the correct Chrome Base to fit BUL69CB? Thank you.

asked by: Jim

0

Expert Reply:

The correct chrome base to use with the # BUL69CB that you mentioned is the part # A69CB that you mentioned.

expert reply by: Jameson C

0

Answer 1

The #BUL69CB LED Utility Light Bar you mentioned can be used for utility use or general illumination, but is not certified by the DOT for use as a back-up lamp as it would be too bright.

view full answer...

Answer 2

Yes, the Opti-Brite LED Interior Strip Light w/ Awning #ILL70CBAWN is considered an exterior light so it would work great on the exterior of your camper.

view full answer...

Answer 3

Yes, the Opti-Brite LED Strip Light for RV Awnings #ILL70CBAWN features a sealed, waterproof housing and lens, which means it can safely be used in fully exposed outdoor locations like the exterior of your camper.

view full answer...

Answer 4

Yes, the Opti-Brite LED Strip Light part #ILL70CBAWN is an exact replacement for your 2016 Winnebago Travato RV. The process to swap this out is super easy. All you need to do is pry the chrome housing off with some sort of pry tool which will then…

view full answer...

Answer 5

I understand why you asked your question. The Optronics Opti-Brite LED Strip Light #ILL71CBAWN is described by Optronics as being sealed and waterproof, and it is also described as being intended for trailer interiors. And yes, it is angled at…

view full answer...

Answer 6

While we do not carry just the bezel or the exact same light with a chrome housing, we do carry the: -Opti-Brite LED Strip Light for RV Awnings - Weatherproof - Chrome Housing #ILL71CBAWN. Similar to #ILL72CB, this light is a bit smaller measuring in…

view full answer...

Answer 7

For a 16 inch strip light that would be the brightest our best solution would be the Optronics part #BUL69CB that you referenced as it's the closest in length at 15 inches and is very bright. Our customers have reviewed this highly and have told…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Chrome Base for Interior Light BUL69CB

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching