Air Helper Springs For A 2020 Mercedes-Benz Sprinter 2500

Question

Question:

Hi, Im considering options for the rear of my 2020 Mercedes Sprinter - 4X4, 170 wb 2500 model. Would like to reduce sway, rocking over speedbumps/driveways/etc. Can you comment on: - Timbren Rear Suspension Enhancement System - SumoSprings Rebel Custom Helper Springs - 2 Piece - Rear Axle - Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle.

asked by: Kevin

0

Expert Reply:

The Timbren Rear Suspension Enhancement System # TMBRSP25A are confirmed to fit your 2020 Mercedes-Benz Sprinter 2500.

Using this system will improve your suspension, handling and safety. They will also absorb road shock and improving roll stability. They have an easy installation with no drilling required.

The system has a 11,000 pound capacity but do not exceed your vehicle's weight carrying capacity.

Firestone does not have airbags available for your vehicle.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

I spoke with my contact at Timbren and the overall height (with spacers) for the part #TMBRSP35B that you referenced is 6-3/8 inch, the height of the #TMBRSP35A is 5-7/8 inch, and the #TMBRSP25A is 5-3/8 inch.

view full answer...

Answer 2

The load that you are carrying on a daily basis is causing your 2013 Mercedes-Benz Sprinter 2500 to sag and bottom out. You will need suspension enhancement and I strongly recommend the Timbren Rear Suspension Enhancement System #TMBRSP25A. These…

view full answer...

Answer 3

We do have an option for you but for your 2021 Winnebago Revel Mercedes Sprinter 2500 4X4 there are currently no supporting airbag system products available. With it being so new designers haven't been able to produce a fitting product that will…

view full answer...

Answer 4

Correct, the SumoSprings Solo Custom Helper Springs part #SSR-338-47 will have a softer ride than the SumoSprings Solo Custom Helper Springs part #SSR-338-54 as it's made of a softer spring. That said, the latter will also provide more support.…

view full answer...

Answer 5

The SumoSprings kit part #SSR-338-54 that you referenced would do a great job removing the sag of your 2014 Freightliner Sprinter BlueTec 2500 when loaded. Installation is pretty easy too so you'd have no problem with that.

view full answer...

Answer 6

You're correct, the SumoSprings Rebel such as part #SSR-327-47-2 is compatible with 4WD vehicles only. For a 2WD vehicle, I'd recommend the SumoSprings Solo, part #SSR-330-47 which would add 900 lbs of support for your payload. For a higher…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 11

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...