Replacement Heat And Cool Wall Thermostat For A Dutchman Original Wall Thermostat

Question

Question:

Have a dometic air conditioning system, with a atwood heat, 1986 year rv fifth wheel trailer,25,000 btu,air conditioning duotherm dometic electric control boxrv ,Dutchman original wall thermostat, mechanical duo therm has failed,,,which mechanical thermostat rv do you recommend for using.

asked by: Steve A

1

Helpful Expert Reply:

The Camco RV Single-Stage Heat and Cool Wall Thermostat # CAM09221 will replace your Dutchman original wall thermostat if your ac is a single-stage thermostat. It will not work with multi-speed air conditioners.

expert reply by: Noah E

1

Answer 1

We've just started carrying the Camco #CAM09221 thermostat, and haven't had the opportunity for our Photo Department to get a photo of the product yet. Camco was nice enough to provide a photo, which I've provided for you.

view full answer...

Answer 2

Realistically it is best to stick with a Dometic replacement thermostat for your Dometic setup. The #DMC79FR is the correct replacement for your 3316410.012. It may be possible to use a universal thermostat like the #CAM09221 you looked at but this…

view full answer...

Answer 3

When wiring the Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR, the solid red wire goes from the positive terminal of your RV's power supply to the control box of your a/c. The positive power wire from the control box to the…

view full answer...

Answer 4

The D-Shaped Bulb Seal for Slide Out or Ramp Gate - Stick On - 15' Long x 1" Tall #SR86FR that you were looking at is not available in 60 foot length, but this particular seal measures 1" tall and 7/8" wide. We also have Rubber…

view full answer...

Answer 5

The Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V is a replacement for your Parallax Converter 6300 model 6345 and would be what you'd need.

view full answer...

Answer 6

For your Parallax/Magnatek 6300A model 6345, I recommend going with the: -Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V. This system has a 45 amp output same as your current model 6345, will work with flooded lead…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 10

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 11

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Replacement Heat And Cool Wall Thermostat For A Dutchman Original Wall Thermostat

Product Page this Question was Asked From

Continue Researching