Recommended Anti-Sway Bars For A 2006 Workhorse W22 Series Chassis

Question

Question:

Will the anti sway bars fit my w22 work horse

asked by: Jim

0

Expert Reply:

For a 2006 Workhorse W22 Series chassis you'll need the Roadmaster Front Anti-Sway Bar # RM-1259-105 and the Roadmaster Rear Anti-Sway Bar # RM-1259-108.

expert reply by: Kevin C

0

Answer 1

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 2

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 3

Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with a…

view full answer...

Answer 4

Your 265/70R17 size tire is around 31-1/2 inches in diameter. You want to make sure the tire cover you get is large enough and doesn't have to be stretched over the tire. I'd rather have one that's slightly loose than one that tears…

view full answer...

Answer 5

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 6

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 7

I trust regular axles with leaf spring suspension more than torsion axles only because I can see what is going on with the suspension and can fix any issues should they arise. With a torsion axle though there really isn't any maintenance you have…

view full answer...

Answer 8

If your step motor marked "REP 851" and the Part Number sticker says "32 Series Step," the replacement step motor kit you need is the Kwikee #LC379145 Motor Upgrade Kit. You can further confirm that you have a Series 32 step kit…

view full answer...

Answer 9

I see what you mean about the cover being "recessed" into the front of the trailer. After looking thru a few pictures of these 2005 Trail Lite Hybrid trailers, it appears to be a fairly unique tank cover. I am sorry to say that we do not…

view full answer...

Recommended Anti-Sway Bars For A 2006 Workhorse W22 Series Chassis

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching