Does The Peterson Accessory Plug and Socket Kit Come With A Fuse

Question

Question:

Does this have a fuse in it?

asked by: Jerry

0

Expert Reply:

The Accessory Plug and Socket Kit - 12V # PE53QV does not come with a fuse inside of it and would need to splice in an inline fuse holder like # SWC9539 and use a 15 amp fuse to properly protect your equipment.

expert reply by: Kevin C

0

Answer 1

There's nothing stopping you from using a Holding Tank Heater Pad such as #277-000164 on black or gray water tanks. However with the black water tank adding a heat source could create excess gases which could be a potential problem.

view full answer...

Answer 2

Yes the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 18-1/4" Long x 12" Wide #277-000164 can be ran off of a 12v DC power source only. I reached out to the manufacturer to verify.

view full answer...

Answer 3

Though I do not know exactly how much your converter sends to the trailer batteries while hooked up to shore power, I would be willing to bet it exceeds the 4.8 amps of the ThermaHeat RV Holding Tank Heater Pad part #277-000164. Please keep in mind…

view full answer...

Answer 4

For as big as your tanks are I would recommend going with the part #277-000163 which measures 25 inches by 7-1/4 inches for each of your tanks. These are designed for the freshwater tanks and would not be needed on grey water.

view full answer...

Answer 5

If the truck has a 12V power wire dedicated to the trailer wiring that is already fused, you do not need to add an additional fuse. For example, on newer GM trucks, the 12V power wire from the factory tow package is ran to a 40 amp fuse in the fuse…

view full answer...

Answer 6

The 12 Volt Outlet with Waterproof Cap #DG6112VP is designed to fit a 1-1/8" diameter cutout. It has a diameter of 1-1/2" at the end and is 1-7/16" long.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...