What Circuits Does LED Trailer Tail Light part # STL73RB Cover

Question

Question:

This light acts as a running light, brake light and turn signal…..correct?

asked by: Michael

0

Expert Reply:

Yes, the LED Trailer Tail Light part # STL73RB does perform function of running light, brake light, and turn signal. The low illumination circuit is for the running lights and the brighter is what activates with the brake and turn signal.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 5

Hey Tim, thanks for reaching out! The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR have a 6,000 lb rating for each Base Pad Extreme so you're looking at a total of 36,000 lbs for this kit of 6. Ideally your jacks will have the…

view full answer...

Answer 6

Hi Michael, While we don't have any way of knowing what winch stand goes on any specific trailer, it is possible we have an option for a winch stand for your Karavan trailer. The only option we have for a stand is the CE Smith Winch Stand…

view full answer...

Answer 7

We can get you a good replacement, though there is actually no longer a TDE brand. But that actuator is simply a bolt-on, 7,500 lb actuator that couples to a 2" hitch ball, and per the owner's manual does not have a lockout (so it is for…

view full answer...

Answer 8

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…

view full answer...

Answer 9

The best way to identify the seal needed, is to get the number that is stamped or imprinted on the seal. You may have to remove the seal in order to see the numbers. If you cannot find the number on the seal, if you can find the numbers on the inner…

view full answer...

Answer 10

The best option we can offer you is the Trailer Idler Hub Assembly part #AKIHUB-545-2-EZ-2K which will be a direct replacement for the Dico Trailer Hub Assembly part 45263 so long as you the Double Lip Grease Seals part #RG06-010. The Trailer Idler…

view full answer...

What Circuits Does LED Trailer Tail Light part # STL73RB Cover

Product Page this Question was Asked From

Continue Researching