Recommended Replacement Roof Vent Lid For A 7x12 2016 Haulmark Enclosed Trailer

Question

Question:

I own a 2016 Haulmark 7x12 enclosed. My roof vent lid broke off and I don’t know what manufacture it is. How do I tell? It does not have a vent fan on it. It’s just the basic crank handle to manually open and close it. Can you help please?

asked by: Scott W

0

Expert Reply:

Since you aren't sure who makes the roof vent on your 2016 Haulmark 7x12 Enclosed Trailer, I recommend going with the:

-MaxxAir UniMaxx Universal Replacement Lid for RV and Trailer Roof Vent # MA00-335001.

This replacement lid is translucent white, and is also universal fit so it will replace your current lid just fine.

If you wanted a more custom lid for your roof vent, you are going to need to determine what fan you have and I'd be happy to see what we have for you.

expert reply by: Bryce D

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 4

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 7

The difference between the two trailer tire sizes is that the letter D in the first size you listed ST205/75D15 stands for bias ply and the letter R in the tire size that they put on your vehicle stands for radial. Radial tires are preferred over…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…

view full answer...

Answer 10

Hi Rick, LaSalle Bristol's roof membrane is made of PVC which is known to be durable and offer better protection against punctures and overall weathering. Alpha Systems offers TPO roof membranes that are more environmentally friendly/recyclable…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Recommended Replacement Roof Vent Lid For A 7x12 2016 Haulmark Enclosed Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching