Recommended Lift Kit For a 5' X 8' Single Axle Trailer To Install Larger Wheels and Tires

Question

Question:

I have a small 5x8 single axle utility trailer with 12 diameter tires and wheels. Id like to install 14 tires. I have plenty of space for the tire width, but Ill need 2 of additional height for fender clearance. Can I just install longer spring shackles to get the necessary clearance? Thanks

asked by: Brent

0

Expert Reply:

I recommend the Correct Track Trailer Alignment and Lift Kit # LC87120 that will allow you to raise your suspension 2-1/4". If you were to extend the shackle strap it would be a very long strap and would put the leaf spring at an angle that would affect how the spring compress since it will be angled forward and not relatively flat to the ground.

expert reply by: Bud M

0

Answer 1

It sounds like you have determined the correct amount of rise you would need in order for you to tow your trailer level. But just for good measure I attached a link to the right that details how to pick the correct rise/drop ball mount for a setup.…

view full answer...

Answer 2

In order to swap out your 13" wheels and tires with 15" you will need to match up the bolt pattern and make sure there is enough clearance. A wheel and tire like the Karrier ST205/75R15 Radial Trailer Tire with 15" White Spoke Wheel…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Yep, so long as your 2024 Subaru Crosstrek Wilderness is not a hybrid both the Curt and etrailer hitches will fit: - Curt Trailer Hitch Receiver #C13382 - etrailer Trailer Hitch Receiver #e98912 The only difference besides price is the finish; the…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

The heat shield actually has to be permanently removed to install the etrailer Trailer Hitch Receiver #e83ZR on your 2024 Subaru Forester.

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

Yes, the etrailer Trailer Hitch Receiver #e83ZR is an excellent choice for your 2024 Subaru Forester! My favorite part about this hitch is the matte black finish because it not only does a great job at matching any black finish on your vehicle, but…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...