Recommended 2" Lubed Dust Cap & Rubber Plug

Question

Question:

I need the center piece that goes in the wheel with a cap on it to get to the grease zirt on the bearings. Its a 2 inch cap.

asked by: Tom

0

Expert Reply:

It sounds like you need the 2" Lubed Dust Cap & Rubber Plug item # DC200L-DCRP. These fit a 1.99 Inch hub bore.

expert reply by: Jerred H

0

Answer 1

When packing a hub's bearings with grease prior to reinstalling it on the spindles (which would be perfectly normal after servicing the brakes) it is possible to over-fill the hub with too much grease. Its human nature: if some grease is good (it…

view full answer...

Answer 2

The best way to determine which dust cap will work for your 2013 Outback trailer is to measure the inner diameter of the hub where the dust cap presses in. This measurement will have to be precise because dust caps come in many different sizes. I…

view full answer...

Answer 3

On a E-Z Lube Spindle #TRU74FR you will pump in Grease #L11390 with a Grease Gun #L30416 until you see it begin to push grease past the spindle nut. If you are using Bearing Buddies #BB84SR the grease will seep around piston edges and into barrel…

view full answer...

Answer 4

An EZ lube spindle will be better because it allows you to insert grease from inside the spindle where the bearings are and push out the old grease whereas with a Bearing Buddy you basically just get to push grease through the front of the hub. I…

view full answer...

Answer 5

In order to add EZ Lube hubs to your trailer you must already have EZ Lube spindles. If your axles do not have EZ Lube spindles these will first have to be welded on by a qualified service technician (welding spindles is not a task that we recommend…

view full answer...

Answer 6

There aren't any stainless steel grease caps with the EZ lube cap on them available in the size you need so your best option is the part #DC200L-DCRP which is zinc coated and has the cap you need.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The absolute best cushioned equalizer that fits the dimensions you mentioned having would be the MORryde ALLTREK 4000 part #MR89DR as this is only option to provide vertical and horizontal cushioning. This would make a big difference and you'd be…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...