Does The Lippert High-Speed Power Stabilizer Jack Have An Automatic Shut-Off Feature?

Question

Question:

When you run the jacks, do you need to stop the motor or does it stop when it reaches its capacity? Same question when you retract the jacks, do you need to stop manually with the switch or does it stop itself with the circut breaker?

asked by: Bruce H

0

Expert Reply:

To extend/retract the Lippert High-Speed Power Stabilizer Jack # LC298707 you will need to press and hold the the switch, as there is no automatic cut off.

However, this jack does have an integrated circuit breaker to protect you from damaging your RV by tripping the breaker if the circuit is overloaded while lifting the trailer.

I have included a review video as well for you to check out as well.

expert reply by: Bryce D

0

Answer 1

I attached a picture that I got from Lippert that shows the wiring diagram for their stabilizer jacks like the part #LC298707.

view full answer...

Answer 2

Yes, the Lippert Components Power Stabilizer Trailer Jack #LC298707 that you referenced does include the switch and breakers needed to complete the install.

view full answer...

Answer 3

The Lippert Components High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift #LC298707 you asked about does have a single motor, but it will allow for leveling on uneven ground as the arms work independently.…

view full answer...

Answer 4

The circuit rating for the motor on the Lippert High-Speed Power Stabilizer Jack part #LC298707 is 20 amps so you'll need to use this along with the distance between the jack motor and battery to find the correct size wire. You can find…

view full answer...

Answer 5

If you have a stabilizer system like Lippert High-Speed Power Stabilizer Jack #LC298707, then you should be able to check out the attached wiring diagram to verify where the fuse and breaker should be. The breaker is inline of the red wire in between…

view full answer...

Answer 6

If the breaker is resetting that means the motor is wanting to draw too much amperage. Since you've replaced the switch already you've narrowed it down to that. For the replacement motor you'd then want the part #LC352338. This is an…

view full answer...

Answer 7

I attached a picture that shows the install instructions for the Lippert Components High-Speed Power Stabilizer Jack #LC298707 that you referenced and in it you'll notice a set distance isn't specified for where it has to install on the…

view full answer...

Answer 8

In regards to the Lippert Components High-Speed Power Stabilizer Jack part #LC298707, the red wire on the motor will run through the 6 amp circuit breaker to the switch. I have attached a diagram of this for you as well although wire colors are not…

view full answer...

Answer 9

Generally a circuit breaker should be installed close to the power source. On a trailer with on-board battery power breakers are best installed near the batteries and each circuit should have a breaker of the appropriate amperage value for the device…

view full answer...

Answer 10

The 20 amp fuse you are looking for on the #LC298707 is a fuse holder like what you can see in the attached diagram.

view full answer...

Answer 11

Replacement pins for the Lippert High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit #LC298707 are actually not available as a replacement. If that pin has sheared away and is non-operational then the only way to get a replacement pin is…

view full answer...

Answer 12

When troubleshooting the stabilizer jacks like the Lippert High-Speed Power Stabilizer Jack #LC298707 the manufacturer provides a few options for what to check when the system is not responding to the switches. Low Voltage: - Test battery voltage…

view full answer...

Does The Lippert High-Speed Power Stabilizer Jack Have An Automatic Shut-Off Feature?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching