Picking Out Replacement Shock for 2003 Hitchhiker II Trailer

Question

Question:

2003 HitchhikerII. Have original shocks, want heavy duty shock replacement for this fifth wheel. Watch your advice

asked by: Dave

0

Expert Reply:

We don't have a way to look up what the shock specs of your 2003 Hitchhiker II are but it's possible we have a replacement solution. If you can take your current shocks off and the compressed length is 8-5/8 inch and extended is 13-1/2 inch then the part # LC283280 would work as a replacement. These are very common shock dimensions so there's a good chance this is the correct replacement you'd need.

expert reply by: Jameson C

0

Answer 1

For the Lippert Bolt-On Shock Mount Kit for 3" Axle Tubes referenced in your question, part #LC281281, the minimum clearance needed from the inside of the tire to the I-beam flange on your trailer's frame (which is needed to install…

view full answer...

Answer 2

The 052-003-00 number on your current shock is the part number from Dexter Axle. We don't carry the direct replacement but if the specs match for the Lippert Standard Replacement Shock #LC283271 and the axle this is being applied to is a…

view full answer...

Answer 3

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5…

view full answer...

Answer 4

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 7

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the…

view full answer...

Answer 8

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

view full answer...

Answer 9

The Repair Kit Fulton Wedge-Latch Cast Head Coupler, #F670801, is designed to fit the coupler #BD44125W0317 which does take a 2-5/16 inch ball.

view full answer...

Answer 10

The Furrion Single Zone Controller part #FACC12SA-BL does have a dip switch setup underneath the cover of it.

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

When installing the WeatherTech Side Window Air Deflectors #WT82476, there is no adhesive strips used on the front deflectors. I have attached a link to an installation video for the deflectors on a 2015 Grand Caravan and as you can see in the video,…

view full answer...

Picking Out Replacement Shock for 2003 Hitchhiker II Trailer

Product Page this Question was Asked From

Continue Researching