Recommended Hanger Kit for 3-Leaf Double-Eye Spring for 2,500-lb Trailer Axles - 25-1/8 Long

Question

Question:

What is the matching bolts and brackets for e66SR?

asked by: Tim B

0

Expert Reply:

The answer to your question will depend on your current trailer setup. If you have a single axle trailer you could use the Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear # APS4. For a tandem axle trailer you could use the Tandem-Axle Trailer Hanger Kit for Double Eye Springs - 3-1/4" Tall Front/Center/Rear # APT5.

If you're using the # e66SR as replacement leaf springs and only need shackle bolts then you can use the # 166081. If you are planning to replace your hangers and shackles you will need to choose the replacements based on the size of your current hangers and shackles.

I have attached a link to all of our available hangers and shackles which can be filtered down by size. I also included a helpful article on trailer suspension which includes how to measure for a replacement for your reference.

expert reply by: Robin H

0

Answer 1

If you got 15 years of regular use out of the #e94SR I'd say you did good in that regard as trailer suspension doesn't typically last forever. It's highly recommended to replace leaf springs on trailer in pairs for the left and right side…

view full answer...

Answer 2

I recommend any trailer with a tandem axle setup use an equalizer regardless of the amount of leaves in the spring or if it is a double eye or slipper spring design. On a system like your trailer where each axle is mounted individually and not…

view full answer...

Answer 3

For your leaf springs that measure 26 inches long from center eye to center eye on your Keystone Cougar with 5,200 lb axles, use the following: - 6-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 26" Long #e94SR The #e94SR are rated a bit…

view full answer...

Answer 4

I did some digging around and found that the Dexter 072-099-01 is a double eye spring that is 26" and 1 3/4" wide with a 6k capacity. For a replacement you can use the 6-Leaf Double-Eye Spring for 6,000-lb Trailer Axles #e94SR. This leaf…

view full answer...

Answer 5

You are correct saying that the leaf spring can stretch a bit over time, and it sounds like that is exactly what happened; you need a 26" (eye to eye) double-eye leaf spring. I recommend going with the 6-Leaf Double-Eye Spring for 6,000-lb…

view full answer...

Answer 6

The number of leaves on a leaf spring does not dictate strength or capacity, so as you said, a 3000lb rated leaf spring (6,000lb axle capacity) can have various numbers of leaves since it is up to how the manufacture designed it. I wouldn't look…

view full answer...

Answer 7

The height adjustment procedure for a 5th wheel hitch will be dependent on that particular hitch but most of the options from Reese have the same procedure which entails unbolting the center section, moving the center section up to the next set of…

view full answer...

Answer 8

In theory a single leaf spring like the part #e46SR that you referenced is going to have a better ride quality since there isn't any inner leaf friction created by the individual leaves of a larger spring pack. Depending on if your current spring…

view full answer...

Answer 9

We have a 6-leaf 6k axle leaf spring with part #e94SR you could use on your 2016 Cruiser Lite 5th wheel that would give you a little more height. These are 26 inches long which is a really common size.

view full answer...

Answer 10

You certainly can go with a 2,500 lb rated axle leaf spring on a trailer that currently have 2,000 lb capacities. It would just give you a slightly stiffer suspension setup. You should note that doing this does not give you any additional weight…

view full answer...

Answer 11

In order to find the correct replacement leaf spring for a trailer you first need to start by noting the type whether that be slipper or double eye. Then, you'll need to measure their unloaded length via jacking up the trailer. If the springs are…

view full answer...

Answer 12

In order to find the correct replacement leaf springs for a 2020 Grand Design Reflections 337RKS, you'll simple need to measure their length, unloaded, from the center of each eye. I recommend going with the Double-Eye Spring for 6,000-lb Trailer…

view full answer...

Recommended Hanger Kit for 3-Leaf Double-Eye Spring for 2,500-lb Trailer Axles - 25-1/8 Long

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching