How To Fix Dash Warning Lights On 2022 BMW X5 with Plug-In Hitch Accessory

Question

Question:

I have a new BMW X5 with a factory installed trailer hitch. I purchased an after market hitch step that has built in turn/brake leds in it. When I plug it it to the factory 4-plug flat connector, it a puts the suv in trailer mode which changes a lot of the suv drive settings and b also causes a check engine light for a tail light fault. If I use this kit to add another trailer connector, will that not cause the fault and or put the suv in trailer mode?

asked by: Marc W

0

Expert Reply:

The Curt Powered Tail Light Converter Kit part # C56190KIT which is a fit for a 2022 BMW X5 won't cause any warning lights on the dash when using a hitch accessory with built-in lights. The harness does not communicate with the vehicle in that respect so there will be no issues. This is a standalone unit that will provide its own trailer lighting signals using the vehicle's taillights.

expert reply by: Conner L

0

Answer 1

The flashing PL code on a trailer brake controller, such as the Tekonsha Prodigy P2 #90885, indicates a power interruption while the brake pedal is depressed. This basically means that when you apply the brakes in your vehicle, the voltage for some…

view full answer...

Answer 2

When installing the Draw-Tite Hitch #76288 on your 2021 BMW X5 (without the M Sport package), you first need to use a 13mm socket to remove 2 nuts from the exhaust (1 each side). Next, you will disconnect the back-up sensor wiring and hands free…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

How To Fix Dash Warning Lights On 2022 BMW X5 with Plug-In Hitch Accessory

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching