Replacement Front Level Up Jack for 2014 Big Country 3700FL

Question

Question:

What lippert leveling jack do you need for the front of a 2014 big country 3700fl

asked by: Calvin

0

Expert Reply:

For the hydraulic Level Up system you have on your 2014 Big Country 3700FL the replacement jack legs for all positions according to Lippert is the part # LC36VR.

expert reply by: Jameson C

0

Level Up Jack Leg
(click to enlarge)

Answer 1

Hello there. The Replacement Hydraulic Jack Assembly for Lippert Level Up System #LC36VR is 21 and 7/16 inches tall and has a travel length of 15 inches bringing its total height to 36 and 7/16 inches tall.

view full answer...

Answer 2

If the Lippert hydraulic leveling system you have on your 2018 Thor Challenger 37KT is the Level Up system then the correct replacement leg you'd need is the part #LC36VR which fits all positions. If instead you have the Level Best system…

view full answer...

Answer 3

The Replacement Hydraulic Jack Assembly for Lippert Level Up System #LC36VR you referenced is for the "Level Up" system so you would actually want the Lippert Replacement Atlas Jack for Kwikee Level Best Hydraulic Leveling System -…

view full answer...

Answer 4

The 195860 code you mentioned is for a center or rear jack of a LCI Hydraulic Leveling system, so the Replacement Hydraulic Jack Assembly for Lippert Level Up System - 8,000lbs #LC36VR is a match to replace your current jack. It has a weight capacity…

view full answer...

Answer 5

According to Lippert, the Replacement Hydraulic Jack Assembly for Lippert Level Up System #LC36VR is a universal fit for Level Up systems and has the same mounting holes to match up. They say it will fit all jack locations so you can use it on your…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Really you're going to need to measure the distance where the leveling system is going to be installed. If that distance is more than 20', then you're going to want the 6 point Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling…

view full answer...

Replacement Front Level Up Jack for 2014 Big Country 3700FL

Product Page this Question was Asked From

Continue Researching