Are Blocks Used for Installation of Draw-Tite Max-Frame Trailer Hitch Receiver on 2017 Honda Odyssey
Question:
2007 Honda Odyssey: Part # 75270 44174CQT75270 Watched the installation video for trailer hitch installation and it showed nothing about the 6 spacers that were included with the hardware. Do I use these as shown on installation sheet ? Also would have gladly paid extra for the spring tool to place the 1 spacer shown in the video. PLEASE ADVISE.
asked by: Rickey G
Expert Reply:
Yes, you use the blacks or "spacers" as shown in the directions for the # 75270. Check out the installation video again beginning at the 1:20 mark. You can see the block held up to the frame and they mention that the blocks will be sandwiched between the hitch and the frame. You can see one sticking out on the end, and the others a few times through the holes on the hitch in the video. Since they are covered by the hitch itself, they can be difficult to see between the frame.
I have attached the installation video and written instructions for your reference.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Video: etrailer Class III Trailer Hitch Installation - 2008 Honda Odyssey
- Article: My Trailer Hitch Doesn't Fit
- Video: etrailer Ball Mounts - Fixed Ball Mount - EBMK4 Review
- Video: Best 2007 Honda Odyssey Trailer Wiring Options
- Shop: etrailer 2-3/4" Rise or 4" Drop Ball Mount Kit - 7,500 lbs
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Ratchet Tie Down Straps w/ Storage Bag - 12' Long x 1-1/4" Wide - 830 lbs - Qty 4
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: hitch
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer hitch
- Video: Choosing the Right Brake Controller
- Search Results: brake controller
- Q&A: Recommended Hitch for a 2024 Toyota Grand Highlander
- Shop: Brake Controller
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Suspension Enhancement
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Search Results: 5504
- Article: Trailer Wiring Diagrams
- Video: etrailer Hitch Pin Alignment Collar Review
- Article: How to Measure for Trailer Hitch Drop
on Trailer Hitch
