Replacement Leaf Spring for 1995 Ellis Tandem Axle Trailer

Question

Question:

Will the 27” leaf spring work on a 1995 Ellis tandom axle trailer. I have a broken one

asked by: John

0

Expert Reply:

In order to find if the 4-Leaf Double-Eye Spring # SP-210275 will fit your 1995 Ellis trailer you will need to know your axle capacity and measure your existing leaf springs. This particular leaf spring is for a 3,500 lb axle. The measurement you need is the spring eye to spring eye measurement.

Keep in mind, your existing leaf springs will be slightly longer since they flatten over time. If you find that you are close to the 27" length of this spring then it will work as a replacement. I also recommend replacing the leaf spring on the side that is not broken as well. To ensure proper axle alignment and suspension performance, leaf springs should always be replaced in pairs.

expert reply by: Robin H

0

Leaf Spring Measurement.
(click to enlarge)

Answer 1

There is no specific torque rating for shackle bolts. You'll want to ensure that the bolts you use are long enough so that when installed you will have at least 2 threads protruding from the nut. Make sure that the bolt you're using…

view full answer...

Answer 2

To properly measure your broken leaf spring you will want to take a measurement from the center of the spring eye to the center pin on the leaf spring along the curve(measurement B in image). As this measurement will be the same no matter how worn…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 5

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 6

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 7

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 8

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 10

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...

Answer 11

Yes, going from a 4 leaf to a 6 leaf spring would add slightly to your ride height. For example, if the current 4 leaf spring has 3/8" thick leaves, and you go to a 6 leaf spring with 3/8" thick leaves, you would be adding 3/4" of…

view full answer...

Answer 12

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have so I…

view full answer...

Replacement Leaf Spring for 1995 Ellis Tandem Axle Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching