How To Set Lock Code On Trimax Resettable Combination Padlock with Shielded Shackle

Question

Question:

How is combination of this lock reset?

asked by: Lillie B

0

Expert Reply:

I have attached for you below the install instructions for the Trimax Resettable Combination Padlock with Shielded Shackle part # TMX68ZR. This requires a flat-head screwdriver.

expert reply by: Conner L

0

How To Set Lock Code On Trimax Resettable Combination Padlock with Shielded Shackle
(click to enlarge)

Answer 1

The Trailer Valet 5X #STC-V211 is rated for 500 lbs of tongue weight. If your 2006 Fleetwood RV Highlander Sequoia 4031 Popup only has 290 lbs of tongue weight then this will do an excellent job at moving your trailer. If you have a drill handy then…

view full answer...

Answer 2

You do not need to look any further. The drill attachment needed for the Trailer Valet 5X Swivel Jack, part #STC-V211 is part #TVDA. This drill attachment can be used wit either 3/8-inch or 1/2-inch drills. The prices for any products can be found on…

view full answer...

Answer 3

If I understand you correctly, it sound like you have a couple of things going. On level ground you want to tow as level as possible, but you don't want to bang up your trailer going in and out of your driveway. I recommend you go with an…

view full answer...

Answer 4

What you need is a little bit of momentum to get the boat trailer over the lip of your garage floor. If you can get the trailer moving at a decent speed (while still maintaining control), the momentum of the trailer will carry it over the lip.

view full answer...

Answer 5

To connect the reverse wire from the Tekonsha OEM Replacement Vehicle Wiring Harness #TK57VR to your 2022 Toyota Highlander you'll need to route it up the paneling at the back of your Highlander, through the boot that connects from your vehicle…

view full answer...

Answer 6

There is not a factory brake controller plug-in port on your 2018 Ford Transit T250 so in order to install your existing Tekonsha Primus Brake Controller you will need to hardwire it in using the Wiring Kit #5506. This kit will provide you with the…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 9

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 10

The BAKFlip MX4 Tonneau Cover #BAK48330 for the 2022 F-250 short bed has 4 panels. While you are using your Demco Autoslide 5th Wheel Hitch #DM8550024 you will be able to keep one panel laying flat on the bed. There are tow ways you can store the…

view full answer...

Answer 11

The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV will be just fine if you need to lift your 2022 Ford F-250 Super Duty, but it will be good practice to lower the psi rating to 5 prior to lifting the truck. I confirmed this…

view full answer...

Answer 12

From what I could find out about your current circuit board, the Atwood Replacement Control Panel #AT91367 will be a direct replacement.

view full answer...

How To Set Lock Code On Trimax Resettable Combination Padlock with Shielded Shackle

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching