Filling Hub With Grease That Has a Grease Zerk Outside The Hub
Question:
I have a Lumina pull behind motorcycle trailer with torsion axles, I have repacked the bearings but am unsure of how much grease to put in the hub. The hub has a zerk fitting on the side wall, do I fill with grease until it starts coming out of the front bearing or is that overpacking?
asked by: Patrick
Expert Reply:
On a hub like the CE Smith Trailer Hub Assembly # CE13511 with a grease zerk on the hub you will remove the grease cap. You will then use your Grease Gun # L30416 to fill the hub with Grease # L11390 until you see it filling the entire hub and covering the spindle nut. Be sure to also watch the grease seal on the back of the hub to ensure that grease does not push through the grease seal.
If you see grease pushing past the seal before it reaches the spindle nut you will have a damaged grease seal or something inside the hub restricting grease from going through the outer bearing.
Products Referenced in This Question
LubriMatic LMX Industrial Strength Grease - 14 oz. Cartridge
- Lubricants Sealants Adhesives
- Grease
- Brake and Bearing Grease
- Standard Lithium Grease
- Lithium Complex
- 14 oz
- LubriMatic
more information >
LubriMatic Professional Pistol Grease Gun
- Lubricants Sealants Adhesives
- Greasing Tools
- Grease Gun
- 7000 psi
- 14 oz
- LubriMatic
more information >
Product Page this Question was Asked From
CE Smith Trailer Hub Assembly w/ Carrying Case for 3,500-lb Axles - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Pre-Greased
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- CE Smith
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Hub for DICO 45264
- Q&A: Replacement Margay Wheel in Gunmetal Gray for ALCOM Stealth Car Hauler
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Hub Replacement Recommendation for DICO Hub part 45264
- Q&A: Dimensions of CE Smith Trailer Hub Assembly w/ Carrying Case for 3,500-lb Axles
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Hub for Tracker TrailStar Boat Trailer
- Q&A: How to Know if the Hub part # 84545UC1-EZ Will fit an Axle Spindle
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Article: Trailer Wiring Diagrams
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Measuring a Trailer Tire