Rear Anti-Sway Bar for a 2013 Tiffin Allegro 31sa Motorhome on a Ford F-53 Chassis

Question

Question:

I have a 2013 Ford 22000 pound chasse with the V10 Tiffin Allegro 31sa Motorhome What anti swaybar do I need for the front and rear.

asked by: Marshall

0

Expert Reply:

For the Ford F-53 chassis you would use Roadmaster anti-sway bar # RM-1139-145.

If your motorhome is more than 33 feet long then you can use # 1139-144. The bar diameter on it is 1-3/4 inches as opposed to the factory 1-1/2 inch sway bar.

expert reply by: Michael H

0

Answer 1

The Roadmaster Rear Anti-Sway Bar, #RM-1139-145, is designed to retain the factory sway bar on 2006 to 2012 Ford F-35 V10 chassis. This kit comes with all of the hardware that you will need to complete the installation and there is no drilling…

view full answer...

Answer 2

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 3

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 4

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the…

view full answer...

Answer 5

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 6

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 7

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 8

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 9

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 10

For a standard replacement equalizer for your Dexter 13-122 equalizers you'd want the #TREQE1 or for a cushioned version you'd want the part #K71-653-00 which comes with new shackles and bolts. For a kit that includes new bolts, bushings, and…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Rear Anti-Sway Bar for a 2013 Tiffin Allegro 31sa Motorhome on a Ford F-53 Chassis

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching