Lionshead 14" Liger Aluminum Wheels

Question

Question:

Ok, How about four AM25DR wheels and four stainless steel caps to go with them? Thanks

asked by: Ken B

0

Expert Reply:

We do not carry the "Tiger" wheels. I contacted the manufacturer and unfortunately the Tiger wheels are being discontinued and we can not get them for you.

Currently we do have the Aluminum Liger Trailer Wheel # LH84FR available in 14".

expert reply by: Scott S

0

Ken B.

5/24/2022

Ok, How about four AM25DR wheels and four stainless steel caps to go with them? Thanks

Reply

Scott S.

5/25/2022

We do have the Aluminum Sendel Series T07 Black Machined Trailer Wheel # AM25DR (x4) available. You can then use the Americana Trailer Wheel Center Cap - Stainless Steel # AM90175 (x4) for the center cap.

Reply

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Yes, we do have the Aluminum Liger Trailer Wheel - 14" x 5" - 5 on 4-1/2 - Gunmetal Gray item #LH84FR in a 15". It is the Aluminum Liger Trailer Wheel - 15" x 5" - 5 on 4-1/2 - Gunmetal Gray item #LH35FR. If you need tires…

view full answer...

Answer 3

I have a solution for you, however I was able to get in contact with the vendor and this wheel is No Longer Available. We are able to ship you the Aluminum Liger Trailer Wheel - 16" x 6" Rim - 8 on 6-1/2 - Black #LH39FR or if you need the…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 9

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

The wheels for your ST215/75R14 sized tire on your 2022 Coleman Lantern 17B are 14" X 5-1/2" wheels with a 5 on 4-1/2 bolt pattern. The Karrier ST215/75R14 Radial Trailer Tire with 14" Galvanized Wheel - 5 on 4-1/2 - Load Range C, part…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...