How To Find Correct Jack Feet Pads for a Keystone Montana High Country

Question

Question:

Do you have RV jack pads for a 2019 montana high country? I dont see it listed?

asked by: Donna S

0

Expert Reply:

In order to find the correct jack pads for your trailer you'll need to know the shape and size of your jack feet. We currently offer jack pads from both SnapPad and Stromberg Carlson for a variety of shapes and sizes. Unfortunately, we don't know what anyone particular trailer uses so you'll need to look through the list attached below for your shape and size.

The SnapPad XTRA Jack Pads for Lippert Leveling Systems part # SP54FR6 for example is designed for round feet measuring 9" diameter.

expert reply by: Conner L

0

Answer 1

The Lippert stabilizer jacks like you have use an 6 amp auto reset circuit breaker and a 20 amp fuse or breaker. If you check out the diagram I attached you'll see how it normally would be wired. For a 20 amp breaker you'd need the part…

view full answer...

Answer 2

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

view full answer...

Answer 3

Westlake tires like the Westlake ST225/75R15 Radial Trailer Tire #LHWL304 that you referenced are the nicest brand we carry. I'd recommend and rate these very highly. You'd really like these and they would work well. They have a higher speed…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

SnapPads like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 6 Item #SP54FR6 can be taken off and on as needed so you won't have to keep replacing them every time you need to take them off.

view full answer...

Answer 6

It is difficult to say without more information. It is really going to depend on the power used by the fridge and the size of your batteries. For example, a fridge like the Everchill #324-000119 uses 11-amp hours of power, so it's going to…

view full answer...

Answer 7

Hey Bryan, thanks for reaching out! Your Reese Elite Series Hitch (discontinued part 30143) has a height range of 14-1/2" - 17" and is only able to secure to the OEM puck system on your 2021 Ford F-450 Super Duty, so we either need to get…

view full answer...

Answer 8

There's unfortunately not a guide to tell us the sizing of your trailer's jack pads so you'll want to measure and note the shape of each pad. I've run into numerous situations where the front and rear pads were either different sizes…

view full answer...

Answer 9

The Clearsource Ultra RV Water Filter System w/ VirusGuard #CS87FR weighs 34.125 lbs.

view full answer...

Answer 10

Hey Jeff, appreciate all the details you provided that was super helpful and we do have the MORryde cushioned pin box that is designed to replace a Lippert Rhino pin box. For the 17,695 lb GVWR you mentioned on the 2024 Brinkley Model Z 3610, what…

view full answer...

Answer 11

Thanks for reaching out, Brian! You'll need the Demco Autoslide Capture Plates #DM6171 to replace the capture plates that come on the Demco Hijacker for your 2024 Ram 3500. I recommend using one of the following Hijacker part numbers since they…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

How To Find Correct Jack Feet Pads for a Keystone Montana High Country

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching