Roof Rack For 2011 Hyundai Elantra 4 Door With Naked Roof

Question

Question:

will this rack fit properly on a 2011 elantra.

asked by: Mark C

0

Expert Reply:

While we do offer roof racks that are a fit for your 2011 Hyundai Elantra, the SportRack Roof Rack # SR1002 is unfortunately not a fit. I would recommend the SportRack Semi-Custom Roof Rack for Naked Roofs, part # SR1010, for your vehicle. Although these racks are very similar, SportRack has designed the door jamb feet of their roof rack # SR1010 to provide a better fit for your Hyundai Elantra. I have linked you to a typical installation video of the SR1010.

You will want to check either your owners manual or with your dealership to see what the weight capacity of your Elantra is when loading cargo on a roof mounted rack.

expert reply by: Jeffrey L

0

Answer 1

The Sportrack roof rack part #SR1002 that you referenced has been confirmed as a fit for the 2010 Hyundai Elantra with a naked roof so it should work well for you. This is a sem-custom roof rack though. So for a rack that is also priced great that…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Luke, Sorry about the confusion, and we can 100% get your 2007 Honda Civic 4-door sedan set up with all the parts needed for a Rhino-Rack roof rack, including both crossbars. You would just need these parts: - Rhino-Rack Vortex Aero Crossbars…

view full answer...

Answer 7

The feet are not separate replacement parts for the SportRack Semi-Custom Roof Rack for Naked Roofs - Square Crossbars - Steel - 50" Long #SR1002. You will need to replace the entire unit to get the feet.

view full answer...

Answer 8

The best way to pick out a fairing for a roof rack is to go with the length of fairing that matches the distance between the feet of the roof rack the best. So for a 50 inch long crossbar most likely the 44 inch long fairing would be the best choice…

view full answer...

Answer 9

All roof racks do make noise. At highway speeds especially the least-noisy bar type is the elliptical shape, also known as an aero-style bar. These make less noise than round and square bars but they still make noise. We have a solution for your…

view full answer...

Answer 10

The best size cargo carrier for your 2017 Hyundai Santa Fe would be one that will fit the roof of your vehicle, offer you enough capacity to carry the cargo you need, and not interfere with the operation of your vehicle's rear hatch. The Thule…

view full answer...

Answer 11

For a basic roof rack system to haul fishing rods on your Corolla I would recommend the SportRack #SR1002 roof rack with 50" crossbars. To that add the Rhino-Rack #RR572 4-pole locking fishing rod holder. Optionally you could use the Rhino-Rack…

view full answer...

Answer 12

I have a solution for you, however the Sport Rack Semi-Custom, part #SR1002 is not a fit for the 2013 Volkswagen Passat. Instead, I recommend the Inno Rack, a kit consisting of: Inno 50 inch Crossbars, part #INB127 Inno Feet for Square Bars, part…

view full answer...