Lead And Follow Leg Repair Kit For A Lippert Venture Landing Gear VMC900R-327953

Question

Question:

Can you give me the correct parts for this jacks,both of them?

asked by: Wayne N

0

Expert Reply:

For your lead jack leg on your Lippert Venture Landing Gear VMC900R-327953, you will want to use the Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear # LC146059.

As for a follow leg kit, you will want to use the Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear # LC146060.

Attached are a couple of review videos for you to check out.

expert reply by: Bryce D

0

Answer 1

The only follow leg I can recommend you use with your Venture landing gear would be the part #LC179014. Stromberg Carlson makes the Venture landing gear, that is the brands are different but the jacks are the same. I cannot recommend you install a…

view full answer...

Answer 2

The Lippert Components Lead Leg Repair Kit #LC146059 and the Stromberg Carlson Kit #LG-146059 referenced in your question are essentially the same kit. I went out to our warehouse to verify this. It is actually not too uncommon for landing gear…

view full answer...

Answer 3

Yes, I attached a diagram you can use to install the #LC146059 that you referenced.

view full answer...

Answer 4

Yes, the Replacement Lead Leg #LC119102 is the correct leg for your VMC900R Venture Landing Gear on your 2009 Keystone Cougar 5th wheel. The Replacement Follow Leg #LC119101 is also available if you would like to replace the follow leg as well on…

view full answer...

Answer 5

I went out to the warehouse and measured the drive shaft of part #LC146059 for you. The total length was about 6-3/8 inches. Between the two closest holes on the end I measured about 1 inch and then from the middle hole to the furthest it's…

view full answer...

Answer 6

Thanks for the photo as well as the description you offered. The Follow Jack Repair Kit for Stromberg Carlson Landing Gear #LG-146060 is the correct fit for your 2010 Coachmen Brookstone 341RE.

view full answer...

Answer 7

The larger gear of the #C37ER has an inner diameter of .587 inch and the smaller gear has an inner diameter of right at 1/2 inch.

view full answer...

Answer 8

We absolutely carry replacement gears like the Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear #LC146060 which will work with Lippert Components powered landing gears, which is the most common landing gear used however…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 11

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye…

view full answer...

Lead And Follow Leg Repair Kit For A Lippert Venture Landing Gear VMC900R-327953

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching