Troubleshooting Compressor Freezing Error On Air Lift WirelessAIR Compressor System

Question

Question:

Commonly remote size compressor freeze but it is not Frozen. Also says compressor low and I have added are 215 lb manually and it still acts the same. If I tell it to go 220 lb it runs for a split second and quits if I tell it to to 5 pounds it releases are for just a second and quits

asked by: Bill W

0

Expert Reply:

I reached out to Air Lift about the problem you are experiencing with your # AL74000. The first thing you should do is check the ground connection. Make sure it is secure and undamaged.

If that does not solve the problem, they suggested that you either undo your power and ground connection or try pulling the fuse and resetting them. Give it about 30 minutes and see if you are still having the issue with the error codes.

If you still have a problem feel free to reach out and I will help you troubleshoot further.

expert reply by: Robin H

0

Answer 1

The biggest difference between the TorkLift StableLoad Suspension, part #TLA7200 is the warranty. Torklift provides a lifetime warranty. The SuperSprings SuperSway-Stop option you mentioned has been discontinued for your vehicle so obviously people…

view full answer...

Answer 2

For your 2010 Open Range 5th-Wheel Trailer, I recommend looking at the Stromberg Carlson Electric Landing Gear Set #LG-4. Each leg on this set is 33-1/2 inches tall and provides up to 19-7/8 inches of travel. It has a combined weight capacity of…

view full answer...

Answer 3

For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly. To test power,…

view full answer...

Answer 4

According to Air Lift, there are a few things that can cause this issue. The problem is likely an air leak between the manifold and the compressor or simply a weak compressor that would need to be replaced. To get the compressor running again so you…

view full answer...

Answer 5

The "P" code on your Replacement Variable Speed Controller for SaltDogg Salt Spreader part #BP54FR is the code for the spinner motor being disconnected. They recommend inspecting the wire harness/motor for damage and then reconnecting and…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

We don't have a way to look up the length of your leaf springs as that's not something that a record was kept for. But I can say that nearly every 3,500 lb axle spring out there needs the 25-1/8 inch replacement like the part #e54SR so while…

view full answer...

Answer 8

The leaf springs we offer for 3,500 lb axles are 4-leaf setups like the part #e54SR which is 25-1/8 inch long. The next capacity we offer higher than this is 4,500 lb which is also a 6-leaf setup with the part number #e27SR. This one happens to be 26…

view full answer...

Answer 9

The Air Lift Wireless AIR Compressor System #AL74000 will show an error whenever there is any type of issue with the system. Generally this is an issue with the remote communicating with the system, a blockage, or a leak. I would inspect the…

view full answer...

Troubleshooting Compressor Freezing Error On Air Lift WirelessAIR Compressor System

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching