Over Under Kit and MORryde Cushioned Equalizer and Wet Bolt Kit for Grey Wolf 23MKBL

Question

Question:

Which MORryde x factor cross support would I need? Thank you.

asked by: Bryce V

0

Expert Reply:

Since you have 3,500 lb axles that are 2-3/8 inch in diameter the correct over under kit would be the part # K71-384-00. For a cushioned equalizer kit the part # MR87ZR would be what you'd want and then for the upgraded hardware kit you'd want the part # MR46ZR.

expert reply by: Jameson C

0

Bryce V.

4/14/2022

Which MORryde x factor cross support would I need? Thank you.

Reply

Jameson C.

4/14/2022

MORryde has a version of the X-Factor Crossmember that was designed to work with the CRE3000 you have with the part # MR33WR.

Reply

Answer 1

The MORryde X-Factor Crossmember for CRE, SRE, or Stock Leaf Spring Suspension #MR33WR includes one adjustable crossmember. Your existing hardware will be too short due to the extra thickness of the crossmember, so you will need to add #MR58ZR if…

view full answer...

Answer 2

The MORryde X-Factor Crossmember part #MR33WR attaches to the leaf spring hangers which are located in-between and in the front and rear of each axle. I have attached a photo below to clarify. Therefore, you'll need three for full support on a…

view full answer...

Answer 3

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 4

Hey Mike, To determine if the MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR would be a compatible fit you'll first want to measure the bolt hole spacing on your current equalizers. The #MR87ZR has a 6-1/2" center to center…

view full answer...

Answer 5

The weight is 54 lbs for the Superwinch S7500 Trailer Winch #SW1475201.

view full answer...

Answer 6

Yes, the MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps #MR76ZR will fit with the Equa-Flex system on your Grand Design.

view full answer...

Answer 7

Hi Alain, thanks for the question and yes, you made a very nice choice for your Grand Design Reflection 337RLS going with the MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps #MR76ZR. This is a very good kit…

view full answer...

Answer 8

I'd be happy to help, but you're going to need to measure the current equalizers on your 2021 Keystone Hideout 29DFSWE to confirm that the MORryde #MR87ZR are going to fit. The #MR87ZR measure 6-1/2" center to center of the horizontal…

view full answer...

Answer 9

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Answer 10

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 11

Most critical to trailer tire performance and durability are 1) proper inflation 2) observance of the tire's rated load capacity and 3) observance of the tire's speed rating. If either of these factors is off the mark then the tire will tend…

view full answer...

Answer 12

I'm pretty sure you are correct that the Coil SumoSprings Custom Helper Springs #CSS-1145R will fit your 2018 Toyota Highlander, however, we haven't had the chance to test this out and SuperSprings doesn't have this listed in their…

view full answer...

Over Under Kit and MORryde Cushioned Equalizer and Wet Bolt Kit for Grey Wolf 23MKBL

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching