Tankless Water Heater To Replace Dometic GC6AA-10E

Question

Question:

My RV has a Dometic GC6AA-10E water heater that measures 16 x12. I want to go tankless and cannot find a replacement tankless water heater. Do you know of any to replace that unit??

asked by: Erik F

0

Expert Reply:

We have what you need, I have a tankless water heater linked below that will work:

**Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - White # LSB64FR.
**Camco RV Water Heater Temperature and Pressure Relief Valve - 1/2" Valve w/ 4" Probe # CAM10423.

This Fogatti unit will replace your old tanked water heater. It has freeze protection and will push 90 gallons of hot water per hour if you really want it to.

You will need to install a relief valve, I have linked it above.

It does need a cut out that is 13" wide x 13" tall x 17-3/4" deep.
It will have an overall dim of 14-3/8" long x 15" wide x 15" tall.

So you will need to do some minor trimming, this is the closest I can get to your required dims.

There is another option that will work and it is the Furrion linked below:

*Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU # FR93FR.
*Replacement Access Door for Furrion RV Tankless Water Heater - 16" x 16" # FR43FR.

It is similar in size and shape just a little smaller in some areas. It has a 2 year warranty and can push about 144 gallons of hot water per hour if needed.

expert reply by: David B

0

Answer 1

I believe what you're looking for is the: -Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm #LC67VR. This arm measures 33" long, and is a direct replacement for the Solera XL 63" long flat awning support…

view full answer...

Answer 2

The two part numbers you are looking at are the same units. One is the manufacturers (FS06B1) and the other is ours #LSB64FR. When it comes to the opening size that you need to install this hot water heater, we state that you need a 13" wide x…

view full answer...

Answer 3

I suggest you first take some measurements to verify fitment. However, specs available to me show dimensions of, 16" W x 12-1/2" H x 18"D. For the Fogatti RV Water Heater #LSB64FR, overall dimensions are 14-3/8L x 15W x 15D. The access…

view full answer...

Answer 4

Thank you for the photos! It looks like you have the Regal Style awning head so for a replacement front cover you need part #LC643923 for the idler side. If there is a clip missing on the back cover then I recommend replacing that as well so the…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...