Can RV Vinyl Flooring, # TS97FR be Glued to Drymax or Advantech Trailer Subflooring

Question

Question:

Can this flooring be glued down to GP Drymax or Advantech trailer subfloor? If so, which adhesive should be used for this? Thanks!

asked by: Ryan D

0

Expert Reply:

Yes, the RV Vinyl Flooring, # TS97FR can be cut to fit and dropped in placed or glue downed for a permanent installation. Use RV Flooring Adhesive for Vinyl Over Wood, # TS76FR for your wood subfloor such as GP Drymax or Advantech trailer subflooring. 1 gallon will cover approximately 150 sq. ft. of flooring.

expert reply by: Michael R

0

Answer 1

Typically utility trailers will just use treated lumber for the flooring. We really only offer vinyl flooring like the RV Vinyl Flooring #TS77FR you were looking at, which is intended for use in an enclosed trailer. You could still use it on your…

view full answer...

Answer 2

The Erickson Horizontal E-Track #E19148 can be cut to length for your application. We suggest using a metal saw or cutting wheel and grinder to cut the tracks to the needed length.

view full answer...

Answer 3

You should really attach E-Track directly to the wood floor of the trailer by trimming the rubber covering in the area you want to mount the track. Also I recommend using several E-track backing plates, #e96RR, under the wood floor so that the force…

view full answer...

Answer 4

I verified with the manufacturer for you that the thickness of the RV Vinyl Flooring - Diamond Pattern - 24' Long x 8'2" Wide Strip - Black #TS89FR is .075 inches

view full answer...

Answer 5

Yes, the RV Flooring Adhesive for Vinyl Over Wood #TS76FR is the correct adhesive to attach the vinyl sheet flooring you have now to your wood floor. This does not require the vinyl to have backing either. There's nothing super special about this…

view full answer...

Answer 6

The 120-LB #M354FR is going to likely be a better option with the door weight between 125-130lbs. While the 150-LB #362SA8207 will work the higher weight will make the door want to raise up off the ground which can be troublesome when trying to load…

view full answer...

Answer 7

The retracted bracket height dimension of the 12-5/8 inches that the Bulldog Jack part #BD190708 that you referenced has is measured from the bottom of the foot to the center of the pipe mount bracket on the side of the jack.

view full answer...

Answer 8

We do carry the Dometic RV Water Heater #DMC74FR which you could use to replace your Atwood G6A-8E 6 gal RV Water Heater, but I highly recommend switching over to a tankless system like the Furrion RV Tankless Water Heater 60,000 BTU #FR98SR. This…

view full answer...

Answer 9

Typically leaf springs will stretch around 1/4 of an inch or so when they are worn out but if the springs are 30 years old I could see it easily being 3/4 inch instead. So based on yours currently being 26 inches long and 30 years old your best…

view full answer...

Answer 10

The Furrion water heater part #FR48SR that you referenced does not use a high voltage circuit like the Atwood water heaters used for ignition so you would need to tape up that circuit and not use it. It would be a good idea to maybe get get rid of…

view full answer...

Can RV Vinyl Flooring, # TS97FR be Glued to Drymax or Advantech Trailer Subflooring

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching