Replacement Options for a Sealed Trailer Light with a Bad Bulb
Question:
How to I replace the bulbs in the tail light assembly - Peterson 440-15. I see no screws or screw holes in the front or on the back of the assemble. Do I need to buy a complete new assemble? This is for a boat trail and the trail go in the water. So assembly needs to be water tight. The right turn light is out but all other lights in the assembly work fine. Thanks for the help.
asked by: Bob M
Expert Reply:
The Peterson 440 series trailer lights typically have 4 screws at each of the corners of the lens that allow you to remove the lens and replace the bulb. It may be possible that you have a sealed version of these lights, in which case the bulb is likely not replaceable without breaking the seal between the lens and the light housing.
You will likely be better off replacing the tail lights. For a submersible light with a replaceable bulb and lens that is similar to the Peterson 440 series light, I recommend looking at the Optronics Submersible Trailer Light - Right Hand, # ST6RB. You do not have to replace both light assemblies if you do not want to, but these lights are fairly economical, so replacing both sides may be a good idea if you want a uniform look on the trailer. The left hand light is part # ST7RB.
Product Page this Question was Asked From
Replacement Stop/Tail Red Lens for Peterson Incandescent Square Combination Tail Lights
- Accessories and Parts
- Trailer Lights
- Light Lenses
- 4-1/2 Inch Wide
- 4-1/2 Inch Long
- Square
- Red
- Peterson
more information >
Continue Researching
- Shop: CE Smith Bow Roller Bracket for Winch Stands - Pre-Galvanized Steel - 13-3/16" Tall - Bolt On
- Video: MaxxTow MaxxHaul Hand Winch Review and Installation
- Video: Review of Deka Wiring - 16-14 Gauge Butt Connectors - DW05744-10
- Video: Buyers Products Trailer Hand Winch Review
- Search Results: winch strap
- Search Results: boat winch strap
- Q&A: Solution for Broken Fulton T600 Winch
- Q&A: Recommended Gauge Wire To Use With Peterson Combination Trailer Tail Light
- Q&A: What is Maximum Length of Strap That Can Be Used On Fulton Single Speed Trailer Winch # FT6000301
- Q&A: Choosing and Installing a Replacement Peterson 7-Function Square Trailer Tail Light
- Q&A: Strap Compatible With Fulton Single Speed Trailer Winch # F142002
- Search Results: bow roller bracket
- Shop: Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 5
- Shop: Fulton Single Speed Trailer Winch - 7" Long Handle - Rope or Strap - Zinc - 900 lbs
- Shop: CE Smith Bolster and Swivel Bracket Assemblies for Roller Bunks - Galvanized Steel - Qty 4
- Shop: Self-Stripping Connector with Waterproof Sealant - 14-18 Gauge - White and Blue - Qty 1
- Shop: Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation - Red - Qty 5
- Shop: Hand Winch Strap with Safety Hook, 2" Wide x 15' Long - 4,000 lbs.
- Q&A: How to Replace 6-1/2 Inch Oval Boat Trailer Tail Light without Screws
- Search Results: 25580
- Shop: Trailer Hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Search Results: winch
- Article: Most Popular Wheel Bearings
- Shop: Trailer Wiring
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Search Results: safety chains
- Article: Trailer Tire Sizing
- Shop: Brake Controller