Choosing and Installing a Replacement Peterson 7-Function Square Trailer Tail Light  

The Fulton Single Speed Trailer Winch, part #F142002, can be used with 15 feet of 2 inch wide strap, like the Hand Winch Strap with Safety Hook, part #DL24239. This is the maximum length that can be used in this winch. It can also be used with a…

You won't need to re-wire the tail lights. The 440-15L has been replaced with the Peterson Combination Trailer Tail Light - 7 part #432400 and part #432400 which does work best with 18 gauge wire however if you having trouble getting the wires to…

The Fulton Single Speed Trailer Winch #F142002 does not come with a strap or a rope. It is capable of holding a 36' x 1/4" Nylon Rope or 15' x 2" Strap #DL24239.

The Peterson 440 series trailer lights typically have 4 screws at each of the corners of the lens that allow you to remove the lens and replace the bulb. It may be possible that you have a sealed version of these lights, in which case the bulb is…

Unfortunately, Fulton no longer has a service kit or spring for the T600 winch. Instead I recommend replacing the winch with the Fulton #F142002. It's actually a replacement to the T600 with a higher capacity.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…