Correct Timbren Active Off-Road Bumpstops for a 2020 Nissan Frontier

Question

Question:

What are tabsosr springs I can’t find on website?

asked by: Jeffrey H

0

Expert Reply:

It sounds like you're looking for the Timbren Active Off-Road Bumpstops part # TABSOSR which are a fit for a 2020 Nissan Frontier. These are great for towing or hauling and will work to reduce sag/squat without minimizing axle travel.

expert reply by: Conner L

0

Answer 1

To install the Timbren Rear Suspension Enhancement System, #TTORTUN4L, on your 2012 Nissan Frontier Pro4x 4x4 you will need to safely raise the vehicle to allow the axle to hang freely, then loosen the axle u-bolts and remove the OEM rubber bump…

view full answer...

Answer 2

For your 2018 Toyota Tundra the suspension enhancement I recommend is the Timbren kit part #TABSOSR because this kit installs easily, gives you the suspension support you need to greatly reduce the sag, and because it doesn't require monitoring…

view full answer...

Answer 3

Yes, you can use the TorkLift StableLoads like part #TLA7311 with aftermarket sway bars. The two products are far enough away from each other they would not interfere in any way. While the picture I attached may not be a Sprinter like your 2014 model…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

Hey Tarek, for your 2023 Ford Raptor I recommend checking out the Timbren Suspension Enhancement System #T75MR. This suspension enhancement system has a load leveling capacity of 3,000 lbs, will increase stability while reducing sag, and will install…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Yes Tarek, the Timbren Suspension Enhancement System #T75MR will work fine with your 2023 Ford Raptor.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Correct Timbren Active Off-Road Bumpstops for a 2020 Nissan Frontier

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching