Camper Tie Down Solution for 2017 GMC Sierra 3500 Dually Crew Cab

Question

Question:

The bed is 8 ft. There is a frame mounted trailer hitch in the back. It does have running boards. Thanks.

asked by: Gregory P

0

Expert Reply:

What is your bed length? What hitch do you have at rear of truck? Do you have running boards?

expert reply by: Jameson C

0

Gregory P.

3/18/2022

The bed is 8 ft. There is a frame mounted trailer hitch in the back. It does have running boards. Thanks.

Reply

Jameson C.

3/18/2022

For your 2017 GMC Sierra 3500 crew cab dually without boards and a factory hitch we have the Happijac tie downs part # LC350763-182971 as a confirmed fit. Then for a set of turnbuckles the Happijac Qwik Load part # LC182895 would work great.

Reply

Answer 1

Yes, the HappiJac Truck-Mounted Camper Tie-Downs #LC182905-182971 is confirmed to fit the 2007 Chevrolet Silverado with the new body, excluding the extended cab. Please note the attached review video.

view full answer...

Answer 2

The HappiJac Truck-Mounted Camper Tie-Downs Item #LC350763-182971 is designed to be used for the front or rear on your 2016 Chevrolet Silverado 2500 and includes the stabilizer bar as requested.

view full answer...

Answer 3

Ryan, yes the Brophy Slide In Camper Tie-Downs #HSBP should work with your 2017 Chevrolet Silverado 3500, but we have not personally tested them with your truck so you'd have to check the diagram attached and see if they'd work for you. These…

view full answer...

Answer 4

Since your current camera only says Voyager that means it is going to be the 1st generation. The WiSight 2.0 Camera #ASA74YR has Voyager 2.0 on the camera. So you are going want a new system with either the 4.3" Monitor #ASA24YR or 7"…

view full answer...

Answer 5

I do have an option for you but there isn't a traditional stop light switch circuit on a 2023 Jeep Grand Cherokee L. Therefore, if you want to use a wired trailer brake controller you'd need a stop light switch like the RoadMaster Stop Light…

view full answer...

Answer 6

I'll start off by saying that the Replacement Cup Holder #195-387597 is designed for the Momentum series recliners and will not control the opening and closing of your Seismic series sofa seating. Unfortunately we do not have an available cup…

view full answer...

Answer 7

There is no weight capacity for the Brophy Clamp On Camper Tie-Downs #HSSF. The tie-down hardware kit #TDHP, that is used to secure the camper to the #HSSF tie-downs has a weight capacity of 3,000-lbs. My contact at Brophy said the tie-downs will…

view full answer...

Answer 8

It is frustrating but the rear tie downs for a vehicle from Torklift are based around what type of hitch is present. So if you went with the TorkLift SuperHitch part #TLD1102 on your truck you would need to go with a new rear tie down. You didn't…

view full answer...

Answer 9

We don't carry the Fastec FIC-3500 electric tongue jack or parts specifically for it. From what I read in online forums both parts and documentation for this imported jack are hard to come by. I was able to find the owner's manual online but…

view full answer...

Answer 10

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 11

Hey Mark, thanks for the question, and while we have exactly what you're looking for, it's actually a different part number (the one you mentioned is for a long bed). I went ahead and verified for you the correct SuperHitch for your 2018…

view full answer...

Camper Tie Down Solution for 2017 GMC Sierra 3500 Dually Crew Cab

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching