HappiJac Truck-Mounted Camper Tie-Downs for 2007 Chevrolet Silverado New Body

Question

Question:

I have a 2007 Chevy Silverado 2500 HD crew cab with an 8 foot bed. It is the new body style. I want to get the happijac kit LC182905-182971 Will this fit my truck? It lists all the different variations, nut not a crew cab 2500hd with 8 foot bed.

asked by: Mark M

0

Expert Reply:

Yes, the HappiJac Truck-Mounted Camper Tie-Downs # LC182905-182971 is confirmed to fit the 2007 Chevrolet Silverado with the new body, excluding the extended cab. Please note the attached review video.

expert reply by: Michael R

0

Answer 1

What is your bed length? What hitch do you have at rear of truck? Do you have running boards?

view full answer...

Answer 2

Yes, the Happijac Qwik-Load turnbuckles are very similar to the Torklift Turnbuckles like the #TLS9529-2-LK so they would work fine.

view full answer...

Answer 3

Did you try the longer rear hooks in the front position of the #LC182895? If those were long enough they are available separately with #LC182896.

view full answer...

Answer 4

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

HappiJac Truck-Mounted Camper Tie-Downs for 2007 Chevrolet Silverado New Body

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching