Fifth Wheel Rail Kit that Fits 2018 Ram 1500

Question

Question:

I have the 5th wheel. I took out of my 2010 ram with a 5.7 ft box. I need the mounting assembly for above the box mount. What part would that be

asked by: Scott

0

Expert Reply:

Reese has the fifth wheel rail kit part # RP50142-58 that's a confirmed fit for your 2018 Ram 1500 which if you had Reese rails already you'd just need the bracket kit part # RP50142 to install them in your truck bed.

expert reply by: Jameson C

0

Answer 1

I checked with Reese, who confirms that for the #RP50142-58 bracket/rail kit the correct dimension from the rear edge of the back hitch mounting rail to the rear edge of the bed (not the tailgate) is 28-15/16 inches. This applies to both the 5 foot 7…

view full answer...

Answer 2

The two parts you mentioned (#RP87FR and #RP39FR) that fit your 2021 Ford F-350 Super Duty will both allow the ability to pull a gooseneck trailer with a gooseneck ball or use a 5th wheel hitch in the puck system. The only difference between them is…

view full answer...

Answer 3

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 4

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 10

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 11

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Fifth Wheel Rail Kit that Fits 2018 Ram 1500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching