Are Road Armor Equalizers Good for Utility Trailers

Question

Question:

Is the Lippert Road Armour equalizer good for a utility trailer or does it compromise durability?

asked by: Shaun H

0

Expert Reply:

Road Armor equalizers like the part # LC696740 are a really great option for utility trailers and would not compromise integrity at all.

expert reply by: Jameson C

0

Answer 1

For the Lippert #LC696740 Road Armor Shock Absorbing Suspension kit, Lippert recommends using the #LC52SV Wet Bolt/Shackle Link kit, which includes 3-1/8 inch shackle links. The slight height and width difference between your Dexter 13-122 and the…

view full answer...

Answer 2

In order to confirm fit of the Road Armor Shock Absorbing Equalizer Kit part #LC696740 you simply need to measure the length of your existing equalizers from eye to eye on center. If they are 6" on center or close then the Road Armor Shock…

view full answer...

Answer 3

The absolute best cushioned equalizer that fits the dimensions you mentioned having would be the MORryde ALLTREK 4000 part #MR89DR as this is only option to provide vertical and horizontal cushioning. This would make a big difference and you'd be…

view full answer...

Answer 4

Hey Doug, thanks for reaching out! The MORryde ALLTREK 4000 #MR89DR dimensions can be a bit difficult to explain via text so I've attached an image giving you the dimensions you're asking about!

view full answer...

Answer 5

I understand your worry Tom, and I have a couple recommendations. First is the MORryde ALLTREK 4000 Shock Absorbing Equalizers #MR89DR which has a height of 4-1/2" for the mounting bolts. This is also 6-1/2" in width like the shorter…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 8

Hi David; nope, the leaf springs don't need to be changed if going to the AllTrek 4000 equalizers. You just need to choose the right one based on your wheelbase (measured center-to-center of your wheels): - 33" Wheelbase: MORryde AllTrek…

view full answer...

Answer 9

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Answer 10

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 11

The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according to…

view full answer...

Answer 12

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Are Road Armor Equalizers Good for Utility Trailers

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching