Bolt Pattern and Nearest Lug Hole Distance On Steel Solid Center Trailer Wheel # AM20035

Question

Question:

What is the center to center measurement? Mine looks like 2 13/16

asked by: Bob T

0

Expert Reply:

The Steel Solid Center Trailer Wheel # AM20035 has a 4 on 4" lug pattern that is measured from wheel lug center across the hub to the furthest wheel lug center. The 2-13/16" measurement that you mentioned is the measurement between the closest wheel lug center to the first wheel stud, not measured across the hub(see image).

expert reply by: Bud M

0

Lug Hole Distance On Steel Solid Center Trailer Wheel # AM20035
(click to enlarge)

Answer 1

I can help you with determining the correct replacement wheel and tires for your trailer with a 6.90-9 tire. Normally you would just need to measure the diameter of the wheel to get the size, but we know a 6.90-9 tire fits a 9" x 4-1/2" or…

view full answer...

Answer 2

Ther trailer tires that we carry, including Kenda Loadstar K364 Trailer Tire - 6.90/6.00-9 #AM10040, are tubeless. You can still use a tube in a tubeless tire though it is not recommended. Given the age of the wheels they may not be compatible with…

view full answer...

Answer 3

Nearly all modern trailer tires are tubeless. Why do you need tubes? You could use a tube with tubeless tire #AM10040 but it can cause it to generate extra heat.

view full answer...

Answer 4

The 6.90/6.00-9 tire size is the same as your 6.00-9 tire size. Trailer tire sizing went through a change in the way the sizes are listed, and the 6.90/6.00-9 size lists both the newer and older sizes in order to indicate that the tire will work as a…

view full answer...

Answer 5

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 8

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 9

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 10

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 11

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 12

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Bolt Pattern and Nearest Lug Hole Distance On Steel Solid Center Trailer Wheel # AM20035

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching