Can 350 lb Tongue Weight Capacity of 2013 Jeep Wrangler Unlimited Be Increased

Question

Question:

I would like to see if there is a way to increase tongue weight capacity to use my hitch mounted motorcycle carrier. The carrier weight is around 100 Pounds and the motorcycle is a Yamaha wr 450 so I think I am right at or slightly above the 350lb states limit. The Jeep does have a 2.5 inch lift Metal cloak game changer Thanks in advance for any help

asked by: Robert B

0

Expert Reply:

Although the Draw-Tite # DT78MR has a 675 lb tongue weight capacity, but you'll be limited to the capacity of the lowest rated component, which is the vehicle itself. Jeep lists a maximum tongue weight capacity of 350 lbs in the owner's manual, and there is unfortunately no way to increase that.

If the weight of the bike can be reduced so it and the carrier's combined weight is less than 350 lbs by emptying the gas tanks and removing the seat and battery, it would be okay to carry the bike but I wouldn't recommend exceeding the tongue weight capacity of the vehicle.

If you can't reduce the bike's weight enough, a lighter carrier like the Ultra-Fab # UF48-979033 which weighs just under 50 lbs might provide the wiggle room you need.

I've linked to a demonstration video featuring the carrier I recommended, as well as to an install video for the hitch.

expert reply by: Mike L

0

Answer 1

Draw-Tite Class III hitch #DT78MR is a confirmed fit on the 2017 Jeep Wrangler and Wrangler Unlimited that have the Mopar off-road bumper 82213654. Of all the hitch options for the vehicle, shown on the linked page, Draw-Tite #DT78MR is the only…

view full answer...

Answer 2

When installed on a 2016 Jeep Wrangler Unlimited, the Draw-Tite 76104 will measure 6" and the Draw-Tite #DT78MR will measure 6-3/8", so it will be slightly longer (diagrams included). These are pretty similar to each other and do…

view full answer...

Answer 3

Draw-Tite trailer hitch #DT78MR will fit if the rear bumper on your 2017 Jeep Wrangler Unlimited is the same as the production Rubicon 10th Anniversary Edition (Mopar part 82213654) or with the standard bumper. If you look at the picture I have…

view full answer...

Answer 4

Any trailer hitch that can safely be used with a weight distribution/sway control system (WD/SC) will indicate this capability on its safety/warning sticker. You cannot use such a system unless the hitch manufacturer indicates that this is…

view full answer...

Answer 5

The maximum tongue weight with weight distribution for the Draw Tite Trailer Hitch #DT78MR is 675 lbs. Weight distribution is designed to distribute the weight more evenly to all axles of the tow vehicle and trailer. Since the weight is carried more…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Bill, The Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA92-00-0450 has a tongue weight range of 200lbs - 450lbs so you'd be right around the middle of the capacity when loaded, making this a great choice. This doesn't come with…

view full answer...

Can 350 lb Tongue Weight Capacity of 2013 Jeep Wrangler Unlimited Be Increased

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching