Distinguishing Between Left and Right Side for Replacement Endcap for Thule AeroBlade Edge Roof Rack

Question

Question:

how do i determine left vs right for the end capsrt. side is passenger side?. Three have fallen off my Mazda C-x 9. The only one remaining is the passengerside back one.

asked by: Charlotte W

0

Expert Reply:

The Replacement Endcap for Thule AeroBlade Edge Roof Rack - Flush Fixed - Left # TH1500052333 is for the driver side of the vehicle. The lock for this endcap is on the right side. The correct part for the passenger side of the vehicle is the Replacement Endcap - AeroBlade Edge Flush Fixed - Right # TH1500052334. The lock for this endcap is on the left side.

expert reply by: Robin H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 5

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 6

To determine if a 2017 Toyota HIghlander has a factory towing harness, start by opening up the rear hatch. Then, lift up on the rear compartment panel and pull it out. Remove the two driver-side panels by pulling up on them. There, you may see a…

view full answer...

Answer 7

Yes, your black spare that you have is one that is compatible with the etrailer hitch part #e98844. It's only the aluminum wheels that won't fit and what you have is not the aluminum one Nick.

view full answer...

Answer 8

I'm happy to help you get what you need for towing. I did a little research to find your 2017 Toyota Highlander SLE AWD towing capacity to be 5,000 lbs. Based on that, you will not have an issue with a 3,850 lb travel trailer with 400 lb tongue…

view full answer...

Answer 9

For your 2017 Toyota Highlander that has a full sized spare, I recommend the Draw-Tite Class IV Max Frame Round Tube Receiver Hitch #DT65MR. This hitch is custom-fit for your vehicle and will allow your full size spare tire to remain stowed under the…

view full answer...

Answer 10

To add a hitch to your 2017 Toyota Highlander, I recommend the etrailer item #e98844. This hitch is custom fit and bolts to your Toyota with included hardware. It is a class III hitch with a 2" receiver. This hitch has a 6,000 lbs towing…

view full answer...

Distinguishing Between Left and Right Side for Replacement Endcap for Thule AeroBlade Edge Roof Rack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching