Can Lippert Solid Stance Be Installed to Rear Edge of RV Step

Question

Question:

Does this have to be installed at the front edge of the step? It seems it would be more comfortable with the install bolts at the back edge of the step when going up or down the steps, especially with bare feet or flip flops.

asked by: Randy

0

Expert Reply:

According to Lippert, the # LC96BJ Solid Stance RV Step Supports can be installed to the lip on the rear of the bottom step, but it'll be more difficult to access the linch pins used to secure the legs in the up or down position.

expert reply by: Mike L

0

Answer 1

The Lippert Solid Stance RV Step Support Kit #LC96BJ that you referenced can install on non-Lippert steps but the requirements are that they are made of steel and have at least 5 inches of ground clearance.

view full answer...

Answer 2

The issue with the Lippert Solid Stance RV Step Support Kit #LC96BJ being used on quad steps is there just isn't clearance underneath them for how much space the #LC96BJ would take up. This adds about 1-1/2 inches of depth to the steps.

view full answer...

Answer 3

The Lippert Solid Stance RV Step Support Kit #LC96BJ will fit Lippert double and triple manual folding steps, and in regards to how it will fit, what you will need to do is check the space you have under your double step. You will need to have at…

view full answer...

Answer 4

As long as the steps of your 2019 Keystone Cougar 338RLK are made of steel and there's at least 5 inches from the ground to the bottom of the lowest step the Lippert Solid Stance RV Step Support Kit Item #LC96BJ will fit and work great.…

view full answer...

Answer 5

You could use air bags and weight distribution at the same time. But if you are experiencing rear end sag on the tow vehicle caused by towing a trailer then the best solution is weight distribution. But not just any weight distribution system. It has…

view full answer...

Answer 6

The Curt front hitch part #31199 is a fit for your 2WD 2004 Nissan Titan. If you check out the install picture I attached you will see that it does not extend out past the front bumper of a vehicle it is installed on.

view full answer...

Answer 7

I do have an option for you but the Stromberg Carlson 4000 Series 5th Wheel Louvered Tailgate part #VGD-10-4000 does not have a spot for the factory backup camera. Therefore you would either need to find a way to mount this yourself, go without, or…

view full answer...

Answer 8

For the Edge CS2 Evolution Diesel Tuner you will need to enter the programming menu. You will turn on your vehicle without starting it. Then use the Menu button to open the main menu and scroll down with the arrow to the Programming on the screen.…

view full answer...

Can Lippert Solid Stance Be Installed to Rear Edge of RV Step

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching