Can Lippert Solid Stance RV Step Support Kit # LC96BJ Install on Non-Lippert Steps

Question

Question:

Is this item only for Lippert Steps or can I add this to my Rockwood 2010 that doesnt have Lippert Stairs. I dont mind drilling holes if needed.

asked by: Sean L

0

Expert Reply:

The Lippert Solid Stance RV Step Support Kit # LC96BJ that you referenced can install on non-Lippert steps but the requirements are that they are made of steel and have at least 5 inches of ground clearance.

expert reply by: Jameson C

0

Answer 1

The rear piece of the toilet sits just above the seat and seat cover so the overall height listed is from the ground to the top of this piece. The Dometic 311 Part-Timer RV Toilet - Low Profile - Round Bowl - Slow Close Lid - White Ceramic #DOM67FR,…

view full answer...

Answer 2

The main difference between the Dometic 310 Part-Timer RV Toilet #DOM57FR and the Dometic 311 Part-Timer RV Toilet #DOM67FR is that the 310 is standard height (20" tall) and the 311 is a low profile (15-1/2" tall). Both toilets will mount…

view full answer...

Answer 3

The Dometic RV Toilet part #DOM67FR is a 311 series RV toilet. For a 3 inch flange then you'd want to use the part #T05-0782 and you'd be set in that regard as well. You'll also need the part #Q23653VP as well and you'd be set.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

Kenny, those bolts for the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W should be torqued to 40 ft. lbs. Also, the pivot arms would need to be torqued to 80 ft. lbs, the draw down bolt should be tighten to 60 ft.lbs and the arms should be…

view full answer...

Can Lippert Solid Stance RV Step Support Kit # LC96BJ Install on Non-Lippert Steps

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching