Replacement Light Cover For Lippert A-Frame Electric Trailer Jack

Question

Question:

I am needing a replacement light cover for my Lippert Electric Trailer Jack with Footplate - A-Frame - 18 Lift - 3,500 lbs - Black Just the light cover got busted. Can I buy just that?

asked by: Sharon C

0

Expert Reply:

The light cover is available as a replacement for your Lippert Electric Trailer Jack # LC285318, but just the lens itself is not something that is made available as a replacement part; so to replace that lens you do need to get the full lower cover:

- Replacement Bottom Jack Cover with Light Lens # LC23UD

expert reply by: Kyle S

0

Answer 1

For the Lippert powered a-frame jack part #LC285318 that you referenced the only way to get a replacement light lens is with the part #LC23UD which is a replacement bottom cover for the jack.

view full answer...

Answer 2

There are 4 screws on the bottom of the bottom cover holding it to the top. And if you remove the cap on the very top of jack #LC285318 you will see 2 more screws. With all the screws removed you should have no problem with the cover. These very…

view full answer...

Answer 3

The Bottom Jack Cover #LC23UD has four screws in it that hold the top to it. You'll need to remove those screws first and take the top #LC285160 off. Once the top is off you can then dismantle the bottom cover from the jack and slide it off.…

view full answer...

Answer 4

I checked and found the manual for the Lippert Electric Trailer Jack #LC285318 and there was no mention of anything going in the hole beforehand to tighten them. I added a cut out of the manual for you which shows the parts for this jack, and it…

view full answer...

Answer 5

Yes for just the rubber plug for the top of the Lippert Jack part #LC285318 that you referenced you'd want the part #LC733924.

view full answer...

Answer 6

There is only one wire that needs to be connected on the Lippert Electric Trailer Jack part #LC285318. This is the red 12 volt power wire that will need to be ran to the positive terminal on the battery. I cannot be sure as to how the junction box…

view full answer...

Answer 7

The membrane of the control panel for your Lippert Smart Jack Electric Trailer Jack w/ Footplate #LC643589 is not replaceable but you can use a cover like the Ultra-Fab Protective Cover for Electric A-Frame Jacks #UF38-944020 to prevent further…

view full answer...

Answer 8

To replace the lens on the Lippert Electric Trailer Jack with Footplate item #LC285318 you will have to purchase the Replacement Bottom Jack Cover with Light Lens item #LC23UD. This will save you some money and effort from not having to replace the…

view full answer...

Answer 9

I have a solution for you but they do not offer just the lens for individual sale. You will need to use the Replacement Bottom Jack Cover with Light Lens for Lippert Electric A-Frame Trailer Jacks item #LC23UD. This will replace the lens and the…

view full answer...

Answer 10

The Bottom Jack Cover #LC23UD of the Lippert jack #LC285318 has four screws in it that hold the top to it. You'll need to remove those screws first and take the top #LC285160 off. Once the top is off you can then dismantle the bottom cover from…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...